At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Your manual should be able to direct you to the location of the fuse box and applicable fuse. Replace fuses only with those of the same rating called for in the manual.
if there is a tow option on that truck check the wiring on the socket for the trailer.and where thy tie in to the rear lites sometimes ther is a short.hope this helps.lucas
First of all,try turning on your blinkers and check the rear lights.If they are working,it is not the fuse.Also try the hazards.If rear blinkers work but brake lights do not,it is probably the brake pedal sensor/switch.It usually is on the back of the brake pedal,a little higher up near the linkage.If you have any questions,reply to this and I will get an autolink to your post and will reply ASAP to go further.Good luck! Greg
No Turn Signal Operation (blinker)The turn signal lights in your car are a basic electrical system that controls the front and rear blinker lights to alert the intended direction of the vehicle. We have listed some of the most common problems and repair troubleshooting tips below: Troubleshooting Procedure To start troubleshooting this problem:
Turn the key to the on position (do not start engine)
Inspect the system fuse located in the fuse panel and replace if needed. If you cannot find the location of the blinker fuse consult your owner's manual or an online repair manual
When a blinker flasher fails it can cause blinker lights to say on, not blink, or not go on at all. To test the blinker system flasher, remove the flasher unit and insert a jumper wire between the two terminals. If blinker stays on in both directions without blinking, replace the flasher. If you cannot find the location of the blinker flasher consult your owners manual or an online repair manual.
If the driver's side tail light is working, it's not a fuse. Use a test light to check for power at the bulb holder. One terminal will be for tail light, the other for brake/turn light. If the is constant power for tail light, replace bulb. If no power, trace wiring from bulb holder to driver's side junction. Probable broken wire between the two tail lights.
×