2006 jeep grand Cherokee headlamp assembly removal( passenger side): got the grill off and the air filter intake removed as well as one of the 3 screws holding the assembly in. However i cant figure out how to get to the 2 screws below the assembly that are blocked by the bumper. It seems that the bumper would have to be removed to get to these 2 screws. Any input would be greatly appreciated!

Marvin

• 85242 Answers
• Posted on Oct 31, 2008

SOURCE: jeep over heating

The cooling fan relays are located there, check the sockets they are plugged into for damage.

SOURCE: HOW TO REMOVE HEADLIGHT ASSEMBLY 2006 JEEP GRAND CHEROKEE

remove the 7mm bolt in the centre top of lamp unit then with a big screwdriver just behind headlamp prise outwards quite firmly

SOURCE: need to get the headlamp assembly off a 2006 jeep grand cherokee

1. Disconnect and isolate the battery negative cable. 2. Remove the cover from over the top of the front lamp unit (1). (Refer to 08 - Electrical/8L - Lamps and Lighting/Lamps/Lighting - Exterior/UNIT, Front Lamp - Removal) . 3. Remove the grille from the front of the vehicle. (Refer to 23 - Body/Exterior/GRILLE - Removal) . 4. If the front lamp being serviced is on the same side of the vehicle as the engine fresh air intake tube, unsnap the air intake tube from the air cleaner housing and remove it from between the lamp and the radiator yoke hydroform. 5. Remove the three screws (3) that secure the two lower and the upper inboard lamp mounting brackets to the front end sheet metal. 6. If equipped, remove the push pin fastener (2) that secures the upper outboard lamp mounting bracket to the top of the radiator yoke hydroform. 7. The lower inboard lamp mounting bracket is captured between a metal mounting bracket on the top of the front frame crossmember and a tab of the plastic front fascia reinforcement. Push the tab of the front fascia reinforcement forward far enough for lamp mounting bracket clearance while maneuvering the lamp unit inboard during removal. 8. Pull the lamp away from the front of the vehicle far enough to access and disconnect the headlamp and dash wire harness connector (5) from the pigtail connector on the back of the lamp housing. 9. Remove the lamp unit from the vehicle.

ZJ Limited

• 17989 Answers
• Posted on Nov 28, 2009

SOURCE: How do you remove the headlamp assembly on a 95

Review the ZJ Repair Manual Secc-8L-Lamps (page 5)

Is an easy work; remember rated this help. Good luck.

SOURCE: instruction foreplacing headlamp assembly 2001jeep grand cherokee

give these websites a try www.alldatadiy.com and www.autozone.com if all fails stop by your local Jeep dealership in the parts department and they be able to print you off the pictures and diagrams you will need wish you the best of luck Michigan Man.