I can not get into my car, Buick Regal 1995,four doors, no remote start. Driver door was a problem one week ago. It could be opened from inside but not outside. it may be the latch was loose. Passenger door was good before both of them get stuck. It seems seat belt got stuck with passenger car door. Trunk was good to open with a key. How can I open it without smash window? Thanks Jason

If 2 door coupe handle on back side of door..they r known to break..if old style look under handle u will c 2 metal if broke only replace handle

Door lock solenoids are connected to the door lock by linkage inside the door. That's the best place for them. You have to remove the door handle and window crank then remove the door panel to get to it.

Don't know if this is aplicable , but I just had this problem with a 2002 dodge . it was ice build up on the bottom of the door .

remove the door trim and you will see nuts inside the door skin that holds the handle assembly on.

PULL DOOR PANEL IN SIDE HANDLE ON WITH RIVITS AND OUT SIDE BOLTED FRON THE INSIDE TO DOOR

YOUR RELAY OR RELAYS COULD BE FAULTY.

R/F door trim will have to be removed. Most likely you will find linkage disconnected from the inside latch of the outside door handle. You might even find a broken piece of the door handle requiring replacement

If it will not open from the outside it could be that the clip came of of the handel inside of the door panel.turn signal could be that the bulb is bad even if it lights up if it doese not flash it is a bad bulb

They are right at the GM dealer, u need a new module, have seen and fixed this very issue, have the dealer do a national inventory search both in Canada and the USA, if the dealer won't, call a US dealer and ask them to try and get the part for U, have done this more than once for out of production parts, always got the part from somewhere.

you need a long screw driver, 10mm, phillips, torxs bits, trim panel popper and a pocket screw driver. if you can hear the actuator working thhere is a plastic replacement boot. pop up the switch cover from the fron. remove the rear reflector/light remover 10mm bolts(3). remove the torx and the open handle cover. then use the trim panel popper and remove the panel. then take the long screw driver and follow tow lock rods to the ned then twist the screw driver. two more rods need to be removed at the back. one has a adjustment. do adjusted it! then remove the torx 30 latch in the outer door part. remove the latch. then two torx 10 on the actuator remove them. at this point you will see a pastic rod that is not connected because the boot came off or the actuator is bad. install the new boot in the latch then take the place rod or the actuator push it into the boot at a 45deg. then swing it down. o ya make sure the gears are aligned top all of the way to the right and the bottom to the left i think. its the same as when you pull it a part. also do not over tightend the actuator to the latch. have fun