-
Chevrolet Master
17,989 Answers
- Posted on Feb 03, 2011
Re: 1994 chev pu compressor replacement
Front
Without Air Conditioning
199198 C/K With Air Conditioning
-
Disconnect the negative battery cable.
-
Remove the instrument panel compartment.
-
Unfasten the forward-most screw in the right side door sill plate. Remove the trim panel from the right hinge pillar.
-
If necessary for access, unplug the ECM wiring and remove the ECM.
-
Unplug the electrical lead at the blower motor and if equipped, remove the underdash courtesy lamp.
-
Remove the bolt from the right side lower instrument panel support. Remove the blower cover and the cooling tube.
Fig. 1: Blower motor wiring
-
Unfasten the flange screws and pull out the blower motor. You may
have to pry back the right side of the instrument panel slightly. Be
careful!
To install:
-
Position the blower motor and install the mounting screws. Be careful not to catch the blower on anything when sliding it in.
-
Install the cooling tube and the blower shield.
-
Install the bolt into the instrument panel support.
-
Attach the courtesy lamp and the blower electrical lead.
-
If removed, install the ECM. Attach the wiring harness.
-
Install the trim panel on the pillar. Don't forget the screw in the sill plate!
-
Install the instrument panel compartment and connect the battery cable.
Rear
1992-98 Models
(see Figure 4)
-
Disconnect the negative battery cable.
-
Remove the right rear quarter panel trim.
-
Disconnect the electrical lead at the fan.
-
Remove the screws and if equipped, the cooling tube.
-
If necessary, remove the fan retaining nut and lift out the blower fan.
-
Remove the blower motor.
To install:
-
Install the blower motor and then position the fan.
-
Install the retaining nut and then tighten the mounting screws to 12 inch lbs. (2 Nm).
-
If removed, install the cooling tube.
-
Connect the electrical lead. Install the quarter panel trim cover.
-
Connect the battery cable.
Fig. 4: Auxiliary heating and A/C system
Hope helps; keep us updated.
×