Cars & Trucks Logo

Related Topics:

Posted on Dec 13, 2017

I have a fisher minute mount plow 2006 and it intermittent problem. the plow won't move uo or down or sideways. I can hear the pump going when I push the up or side ways buttons but it does not move. Fluid is ok, just filled it. I wait and move the witres and it starts working again for a while. Any ideas?

5 Related Answers

Anonymous

  • 350 Answers
  • Posted on Jan 19, 2009

SOURCE: stalling when going from R to D while plowing snow

It sounds like your draining your battery with all the accessories. It could be a loose alternator belt or that the belt is just getting wet and slipping or your alternator is not up to the job!
Try going to a good auto parts store like Advanced Auto and ask them if this could be the problem. They may be able to swap up your alternator to one that can handle the load!
Good Luck!

Ad

Anonymous

  • 67 Answers
  • Posted on Dec 11, 2009

SOURCE: with plow lights pluged in do not have low beam on

ca mention may be wrong un plug the 2 chk fuse and start overthen u no

cy schousboe

  • 2002 Answers
  • Posted on Dec 17, 2009

SOURCE: Lights on a fisher xtreme plow wont work

I'm guessing that you have already checked to make sure there is power going to the plow lights. If not use a test light and make sure. The most likely problem is the grounds from the plow lights themselves to the frame. Take the lights apart and check and/or replace the grounds, wires inside the case take a lot of vibration and that can cause them to fail.Don't forget to check the bulbs to be sure they're good too. Hope this helps.

oldmanewtoys

Rick Rife

  • 414 Answers
  • Posted on Feb 26, 2010

SOURCE: my fisher plow wont move

Sounds like pump is not working, check all fuild lines. Unless the plow is all electric, then the ground

Anonymous

  • 1 Answer
  • Posted on Nov 13, 2010

SOURCE: fisher minute mount goes up and left and locks up

check your connections, especially the main power plug in, i have used a small "c" clamp over the connection to aid in the same problem

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

MM PLOW WILL NOT MOVE AT ALL. PUMP IS RUNNING. WHAT CAN CAUSE THIS?

mm means what, Mickey Mouse? LOL

pumps fail many a way.
sucks air
leaks bad runs drive.
impeller bad.
filters.
or not primed.

Fisher Minute Mount MM 1 or MM 2 plow
i guess elect motor spins ok and oil is full
so bad pump is sucks air or is not primed and is air locked.

mm1-undefined-undefined-0.jpg
0helpful
1answer

I have a minute mount plow, when I try to use it only goes to left and right side but doesn't go up, when I try to lift the plow goes to the right. What can I do

2002 Fisher Minute Mount Inst-Act Wont Angle [Archive] - PlowSite ...

www.plowsite.com > ... > Truck & Equipment Repair

Nov 17, 2011 - 90 posts - ‎9 authors
My plow went up it was jerking and did it in steps , but , it got there . Now , it onlyjerks when i try to angle it right or left or up . I filled the fluid ... Drop it and if it doesn'traise you can just use a jack and shorten the transport chain to hold it. .... I do havecontinuity on the plow side for all 3 wires going to the plug . Hooking Up A Fisher Minute Mount 2 In Under 1 ...
54 posts
Feb 1, 2011
Plow Wont Angle
32 posts
Oct 19, 2010
What's wrong with my plow?
21 posts
Jan 9, 2003
Looking For Minute Mount Tips
57 posts
Feb 13, 2002
More results from www.plowsite.com

Ultramount Intermittent Angle Problem - Snow Plow Forum - L


1helpful
2answers

When i try to lift or angle my plow all i get is a clicking sound when i push the lift button and when i let up on the button the moter on the hydrolic unit will click but will not move the plow. minute...

Not familiar with model, but valves click at the same time motor is suppose to run. Check power and ground to motor (or try running it with jumper cables, but don't be where plow can angle and squish you. If good power but won't spin, clean brushes/commutator/check bearings in motor.
0helpful
1answer

Fisher minute mount plow

does the pressure release close to raise the plow?
0helpful
1answer

Fisher minute mount 2 plow won't move.the motor runs but no plow movement? Is the pump bad?

You may have to bleed air out of the system to get it to work properly. Hope this helps.
5helpful
1answer

My fisher plow wont move

Sounds like pump is not working, check all fuild lines. Unless the plow is all electric, then the ground
6helpful
2answers

My fisher plow wont work after i hitch it up .... i can hear the sylinoid click but nothing moves ... was working then all of a sudden wont

my meyer plow well not go up or down and well not go side to side , it does make a clicking sound , what wrong with it
0helpful
1answer

Fisher minute mount goes up and left and locks up

check your connections, especially the main power plug in, i have used a small "c" clamp over the connection to aid in the same problem
Not finding what you are looking for?

408 views

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...