2001 Oldsmobile Alero Logo
Posted on Jul 20, 2008

The heater / ac blower only works on high. It is not the blower or the control switch or the blower motor relay. Please help. Thank George

  • 3 more comments 
  • spage38 Jul 28, 2008

    My problem is similar, however in addition to only running on high speed it remains running even after the key is off.



    Have not replaced anything yet, because not sure what is problem. I have been told everything from a/c control head, relay, blower resistor?



    Thanks in advance.

  • Anonymous Sep 16, 2008

    I have the exact same problem. The blower will only work on the 2 highest settings.

  • mlogrady Feb 28, 2009

    Fan went out. 30 amp fuse in engine compartment had blown. Replaced fuse and I was left with high speed only. Replaced the resistor (it was definitely fried). Still only have high speed. Did I miss something?

  • Anonymous Mar 17, 2014

    3.9 v6
    Heater and ac

  • Anonymous Mar 21, 2014

    motor don't come on

×

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 3 Answers
  • Posted on Sep 17, 2008
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Sep 16, 2008
Answers
3
Questions
0
Helped
2765
Points
30

It is the blower resister. I purchasted one at auto zone for $18.00. It is located under the passenger side dash. You need to remove the glove box and the plastic cover under the dash to expose the blower motor. the blower motor resister is right next to the motor. Simply unplug the resister remove the two screws and replace. I did this and now my fan works on all speeds.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2helpful
1answer

1992 323 mazda want blow heat out

REPLACE THERMOSTAT.IF ALREADY DONE.CHECK HEATER BLOWER MOTOR SEE IF POWER GOING TO HEATER BLOWER MOTOR.IF YES BLOWER MOTOR BAD.IF NO POWER GOING TO BLOWER MOTOR CHECK AC AND HEATER CONTROL FUSE AND CHECK BLOWER MOTOR FUSE AND RELAY IF ALL IS GOOD CHECK SEE IF POWER GOING TO AC AND HEATER CONTROL SWITCH IF YES THE AC AND HEATER CONTROL SWITCH COULD BE BAD.
2helpful
1answer

Heater and air stopped working on my 2000 Ford Focus zx3

CHECK BLOWER MOTOR FUSE AND RELAY.SEE IF POWER GOING TO BLOWER MOTOR YOU HAVE FAULTY BLOWER MOTOR.IF BLOWER MOTOR FUSE AND RELAY OKAY.IF NO POWER GOING TO BLOWER MOTOR BUT POWER AT AC AND HEATER CONTROL SWITCH. BLOWER MOTOR HAS POOR GROUND OR AC AND HEATER CONTROL SWITCH IS BAD.
0helpful
1answer

My 97 buick lesabre limited heater/ac blower quit, it has the climate control,I checked all fuses.

REMOVE HEATER BLOWER MOTOR HOT WIRE BLOWER MOTOR IT.IF IT WORKS.YOUR AC AND HEATER CONTROL SWITCH IS FAULTY.CHECK HVAC FUSES AND CHECK BLOWER MOTOR RELAY.IF BLOWER MOTOR DONT WORK WHEN HOT WIRE REPLACE IT.IF ALL CHECK OUT GOOD.HAVE DEALERSHIP DO A DIAGNOSTIC TEST ON YOUR CLIMATE CONTROL SYSTEM.
0helpful
1answer

Heater/ac blower not working, at times it only worked on high, or not at all. i've replace the resistor, could it be a relay or ?

It is not a relay. If you have replaced the resistor pack, then the blower motor speed control switch on the dash is bad. I am assuming you know the blower motor is good.
0helpful
1answer

I have 2002 infinity I35 and the blower motor stop working ,I took out the blower motor to make sure was good. YES the blower motor still working .the only think I really don't know how to check is Blower...

WELL YOU HAVE TO USE A VOLT METER CONNECT ONE VOLT METER WIRES TO GOOD GROUND AND THE OTHER VOLT METER WIRES GOES TO EACH SWITCH SPEED.IF VOLT METER GET VOLTAGE A 1 OR 2 CONTROL SPEED RESISTOR BAD.IF RESISTOR BAD YOU WILL GET 1 OR 2 BLOWER MOTOR SPEEDS.IF BLOWER MOTOR WORKING.CHECK THE AC AND HEATER CONTROL SWITCH FUSE OR CHECK BLOWER MOTOR FUSE AND RELAY.IF ALL GOOD SO FAR CONTROL SWITCH ITSELF COULD BE FAULTY.
8helpful
3answers

I only get the fan to work on high speed, the lower speeds do not work

Hi!!
The Blower Motor Resistor also called Manual Temp. Control resistor), is fried, replace. The price with floor console $25 and without floor console $65. here is a pic.
87b9810.jpg

the resistor is located on the blower motor housing, fastened by two screws. It is the part where the electrical plug connects, the plug on the pic. goes to the blower motor.
A HELPFUL - 4 THUMBS rating for this solution would be greatly appreciated. Thank you for using FixYa.
1helpful
1answer

THE AC WONT BLOW OR THE HEATER

CHECK BLOWER MOTOR FUSE AND RELAY.IF BOTH GOOD.REMOVE BLOWER MOTOR HOTWIRE IT.IF DONT WORK REPLACE BLOWER MOTOR.IF BLOWER MOTOR WORKS.HEATER AND AC CONTROL SWITCH IS BAD.
0helpful
2answers

Vent

Get a new blower motor and relay.
4helpful
3answers

1996 nissan sentra ac/heater switch works only on high. need help

I had the same prblem. There is a relay next to the heater blower that needs to be replaced.
Not finding what you are looking for?

969 views

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...