There are two sensors.The output speed sensor and input speed sensor.
It may be on top of the Trans, a small sensor with a 2 wire connector pluged into it. There will be another that looks the same, this is the input speed sensor. The one of these closest to the crankshaft is the input speed sensor, the one a little higher and closer to the axle is the output speed sensor. Should be a 10mm bolt that bolts striaght down and holds the sensor in.
If it is not this, the the input and output speed sensor will come together and you will need to lift up the front left corner and take that tir and plastic guard off. The input and output sensors will be connected and easy to access from there, they will be connected by a wire that runs up by the transmission mount across to the other side and has a connector right there on the front side of the transmission.
--------------- This will help.Thanks. Helpmech.
1,448 views
Usually answered in minutes!
×