Tests/Procedures:
1. Perform zero point calibration of the yaw rate sensor/deceleration sensor.
Potential Causes:
Deceleration Sensor Zero Point Calibration
Tech Tips:
Code C1336 is for Deceleration sensor zero point calibration undone. To perform zero point calibration, have the steering wheel in the straight ahead position and have the vehicle on a level surface within an inclination of 1%. Turn the ignition switch OFF. Use a jumper wire and connect terminals TS and CG of Data Link Connector (DLC) 3. Turn the ignition switch ON. Keep the vehicle stationary on a level surface for 2 seconds or more and verify that the VSC warning light blinks.
Diagnostic Codes:
C1336
2,187 views
Usually answered in minutes!
×