Question about 2003 Jeep Liberty

1 Answer

HOW DO YOU REPLACE THE REAR WIPER MOTOR ON A 2003 JEEP LIBERTY?

Posted by Anonymous on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 117 Answers

REMOVAL

  1. Disconnect and isolate the battery negative cable.
  2. Remove the rear wiper arm from the rear wiper motor output shaft.
  3. Using a small thin-bladed tool, gently pry at the notch in the base of the rear wiper motor output shaft bezel to unsnap the nut cover from the bezel .Be certain to take proper precautions to protect the outer tailgate panel and its paint finish from damage during this procedure.
  4. Remove the nut that secures the rear wiper motor output shaft to the outer swing gate panel
  5. Remove the bezel and gasket from the rear wiper motor output shaft.
  6. Remove the trim panel from the tailgate inner panel.
  7. Disconnect the tailgate wire harness connector for the flip-up glass ajar switch from the flip-up glass latch connector receptacle.
  8. Disconnect the tailgate wire harness connector for the rear wiper motor from the motor connector receptacle
  9. Loosen the two screws that secure the rear wiper motor mounting bracket to the top of the tailgate inner panel.
  10. Slide the rear wiper motor and mounting bracket forward far enough to disengage the two mounting screws from the keyed slots in the top of the tailgate inner panel.
  11. Remove the rear wiper motor and mounting bracket from the tailgate as a unit.
To Install just reverse steps

Posted on Jan 23, 2011

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: 2003 Jeep Liberty rear wiper does not work

how is it not working, entirely not running, or just doesn't come in contact with the glass?

Posted on Mar 31, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Rear wiper not working 2002Jeep Liberty


There's this website www.reliable-store.com
They have books on ALL vehicles.
it covers wiring diagrams, electrical diagrams,
fuse diagram, torque specs, PCV, error codes, fault codes, service info, repair info, parts info, troubleshooting owner's/service/repair/parts/maintenance manuals
etc everything totally..
I have 1987 toyota 4runner model and I keep servicing and when needed repair it on my own. worth it !!!

Mar 17, 2018 | Jeep Cars & Trucks

1 Answer

2003 jeep liberty front wipers not working


check if the motor is getting 12volt current with a multimeter

Feb 22, 2014 | 2003 Jeep Liberty

1 Answer

Rear wiper does not work, it is receiving power


If the wiper motor has power and ground, I would suspect that the motor has failed.

Feb 09, 2013 | 2003 Jeep Liberty

2 Answers

Rear windshield wiper sprayer doesn't work but the fronts work fine 2002 jeep liberty limited


The rear wiper has its own pump motor. pull the hose from the wiper and have someone engage to see if there is a clog. do the same at the motor. if bo liquid comes out then its the pump. also check fluid level in reservoir as well as a possible secondary reservoir

Dec 01, 2012 | 2002 Jeep Liberty

1 Answer

Jeep Liberty '03...need to repair rear window washer/sprayer and probably tube....that snapped off. Parts needed? Access through bumper?? Thank you for ANY suggestions.


Not so simple procedure, try and follow all your steps and replace all screws...Not familiar much with the Liberties but, usually access to the wiper will be somewhere in the back of the hatch. You can pretty much figure it out from there.

Apr 27, 2011 | 2003 Jeep Liberty

1 Answer

Rear wiper not working when try to turn it on nothing happens on my jeep liberty


first check fuses if all good remove back hatch panel find wiper motor remove plug . turn the ignition key to on position turn on rear wiper now test wiper plug for power if no power replace wiper motor

Jan 04, 2010 | 2004 Jeep Liberty

1 Answer

Jeep LIbery rear windshield wiper not working


it sounds like you've traced everything except the actual switch or possible the relay. check the moter ground that goes to the body.

Jan 31, 2009 | 2003 Jeep Liberty

4 Answers

2003 Jeep Liberty rear wiper does not work


If there is a separate switch for the rear wiper there might be a separate fuse. Check to see if your rear window cleaner works. If it doesn't check your fuse. If it does work i suggest that you replace the switch or check the connections of the switch. I hope this helps.

Dec 02, 2008 | 2003 Jeep Liberty

Not finding what you are looking for?
2003 Jeep Liberty Logo

2,080 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85178 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...