Turn signals only work sometimes - 2000 Chrysler Town & Country

Drivers side of steering column under dash, check flasher make sure its tite, turn key to on, turn signal on, move flasher round see if turn signal starts working replace flasher try it agian might be bad connection

sounds like a bad flasher switch. wiggle flasher switch when turn signal is on to see if it makes it work or not

https://s1.postimg.org/89tia75ozz/turn_signal.jpg

Click on the link.
This is for turn signals. Get at the turn signal switch. See the purple wire, L terminal on top of turn signal switch in diagram, that should go hot with key on, use jumper wire from that terminal to one of the wires on bottom of turn signal switch in diagram, those are, front/rear, left/right turn signals. If the turns signals work properly with the jumper, but, other wise don't, the problem should be the turn signal switch. If it still doesn't work properly, you would have to check wiring circuits.
Sometimes a faulty ground can cause weird problems. Sometimes the bulb doesn't make good contact in the bulb socket? Try putting a little pressure on the bulb in the bulb socket, see if it starts working?

check the bulb and socket it may have worked loose. if this id not it the turn signal assembly may be bad and need replaced. hope this helps

You more likely have a bulb that is no good. The next time your signals aren't working, pull over and check to see which bulb isn't working. Make sure the turn signal is on while checking. It should only be the left or right. Not both. Sometimes you can see the blown bulb with the hazards on depending on your model vehicle. Simply check the bulb thats not blinking for a tight fit. Then replace it if thats not the cure.

You need to change the passenger front turn signal bulb.

possibly flasher unit faulty
or turn signal switch

I think there is a recall on this.

Sounds like you have a short in the turn signal switch ( in the steering column). Depending on the different functions of this switch will determine the cost. If you have one that simply works the turn signals, then your looking at about $15. I believe yours should cost around $75 since it's a multifunction type. Installation time is about 20 minutes

multifunction switch? I think so.