Question about Mitsubishi Montero Sport
Are you sure this isn't the clutch release bearing making noise, I bet it is.
Posted on Apr 18, 2017
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: Rear Axle Bearing Replacement
That absolutely sounds like an axle (wheel) bearing. Jack up that corner of the truck and grab the top and bottom of the wheel, and shake like crazy. If you have any play whatsoever, it's a sign of a bad bearing (although you could have a bad one and not have any play - it would only mean the bearing isn't worn badly enough to cause looseness in the wheel).
You should be able to remove the axles without opening the diff up. If the axles have c-clips or snap rings on the ends inside the diff, you can usually get the axles out by dismounting them from the hubs and getting them free of all attachment except the diff, and then use a large flat-tip screwdriver as a pry bar. Use it right where the axle body mates to the diff, and lever it while you pull/yank/shake/swear at the axle, and you'll manage to pop the axle out of the diff. Sometimes it takes some time and profanity, but so far it's worked for me everytime.
Posted on Aug 02, 2008
check your rear end and make sure it has plenty of gear oil..if full then there is friction in it somewhere and it is probly getting ready to go out.
Posted on Dec 02, 2008
it all depends on which type of bearings are fitted to the front hubs if there are 2 taper bearings fitted I:E one at either side of the hub then you can get away with knocking them out with a copper dollt. If it is one continuous bearing running through the hub then it is easer to press it out rather than trying to knock it out
Posted on Apr 23, 2009
SOURCE: We were travelling at 70-80 kph in our Mitsubishi Pajero 2000 model Fieldmaster , automatic transmission when our grandaughter accidentally kicked the transmission lever from drive to neutral. The veh
no i do not think its your tran. it could be a dust shield or a heat sheld came lose. it happen to me befor .and the car was fine. ok have a nice day
Posted on May 04, 2009
Tips for a great answer:
Aug 07, 2016 | 2005 Mitsubishi Pajero 3.5
Jun 11, 2016 | 1997 Mitsubishi Pajero
Mar 04, 2016 | Cars & Trucks
Jun 03, 2015 | 1997 Mitsubishi Pajero
May 29, 2011 | 1992 Mitsubishi Montero
May 18, 2010 | 1997 Mitsubishi Montero
Mar 14, 2010 | 1997 Mitsubishi Montero
May 04, 2009 | Mitsubishi Montero Cars & Trucks
Sep 20, 2019 | Mitsubishi Cars & Trucks
Sep 16, 2019 | Mitsubishi Eclipse Cars & Trucks
88 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: