Question about Dodge Ram 150

1 Answer

I start the car and the abs light goes off, then driving along the brake light and abs light comes on for no reason.

Posted by Anonymous on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 357 Answers

Possible faults:

Different tire rotational speed wheel to wheel.

Broken wire loom to wheel sensor.

ABS Tone ring missing teeth, broken.

Bad ABS wheel sensor.

Dirty Tone ring...... brake dust and rotor dust.

There is always a reason for warning lamps to illuminate.

Posted on Jan 15, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What would cause the Emergency Brake light to not go off when the emergency light is released? What causes the ABS warning light to come on?


When I had that problem with the emergency light it was the sensor for emergency brake
The abs and brakes sounds like you are loosing pressure in the system

Apr 18, 2015 | 2004 Toyota Prius

1 Answer

Ebcm


My ABS and Brake light goes on alot. Also sometimes my gages will go up and down for no reason. That is what they call the GM shuffel. It happens to alot of GM vehicles.
I never had a problem with loosing power or the tranny stuck in second gear. Sounds electrical, if no one can help here, get that thing to a garage before your hurt.

Jul 15, 2014 | 2001 GMC Jimmy

2 Answers

Why does the "service traction system" and "service ABS" light to come on when driving?


The service ABS light on while driving means that the ABS wheel speed sensor is defective or a broken wire that goes to the sensor. You now only have regular braking. This means that you can now lock up one or more wheels with hard braking. Then the car can swerve either left or right while braking hard. The traction control must also rely on the ABS wheel speed sensor to keep both front wheels spinning at the same speed for safety reasons. This prevents loss of control of your car while getting better traction with the tires.

Jun 25, 2014 | 2000 Pontiac Montana

1 Answer

Brake and abs light


Check to see if your emergency brake is partially on. Also the abs light goes on when the sensors on the hubs get corroded from salt. They either need to be cleaned or replaced. Mine are on from corrosion from road salt so rather than pay the hefty fee to fix the issue until I can do it myself I just pulled the fuse for ABS in my panel to shut that system off. Perfectly safe to drive without them and not an inspection requirement. Now your abs is probably going on every time you apply the brakes and that is not a good thing!

Apr 16, 2014 | 2002 Chevrolet Avalanche

1 Answer

Meaning of ABS light


On vehicles equipped with antilock brakes (ABS), a second warning light is provided to warn if a problem occurs within the ABS system. The ABS lamp comes on when the ignition is turned on for a bulb check, then goes out after the engine starts. If the ABS warning light remains on or comes on while driving, it indicates a fault has occurred in the ABS system.

What happens next depends on the nature of the fault. On most applications, the ABS system disables itself if the ABS warning light comes on and remains on.

Oct 24, 2012 | 1999 Ford Ranger SuperCab

1 Answer

I have a problem with 2000 VW Passat. ABS and brake light comes on randomly while driving or after just starting the car and goes off in one or two seconds. However today when i started my car bot ABS and...


Could be many reasons. May be a sensor in the brake system. A garage will have the code readers and will check it. As it's a safety item I would recommend that you refer to a garage right away. The scope of the question us too large to answer with any certainty on here

Jun 01, 2017 | 2000 Volkswagen Passat 4Motion

1 Answer

When I start the acceleration, the brake light comes on for just a few seconds and goes out. I checked the fluid levels.


If there is ABS on the car it is the ABS detecting the difference inthe wheel RPM that is triggering off the brake light.
so not to worry as this happens and specially if your brake fluids are full.
The other reason is the momentum is setting off the brake fluid sensor to switch on .

Sep 30, 2010 | 2007 Suzuki Grand Vitara 4WD

1 Answer

The ABS Light and msg cnter on 2005 Jeep cherokee is coming on.


You have to check you brakes yourself or take it to the shop, I had a brake light on and once I change the rotors and brake pads the brake light went off.





Melvin

St Louis

Sep 26, 2009 | 2005 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

296 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...