I have one dodge stratus r/t 2005 tha code in tha machine is P0205 and P0305 . What is posibility problem? thanks

2005 Dodge Grand Caravan 3.8L engine misfire on cylinder 5.

answers.edmunds.com > Edmunds Answers

Aug 14, 2012 - MIL on; cylinder 5 misfire; most noticeable at idle in gear ... This could be caused by an EGR valve that is sticking partly open and not closing ...

OBD-II Trouble Code: P0305 Cylinder 5 Five Misfire Detected

www.obd-codes.com/p0305

A P0305 code means that the the car's computer has detected that one of the engine'scylinders is not firing properly. In this case it's cylinder #5.

ODB Code P0305- Misfire in #5 Cylinder - 2008 Dodge ...

repairpal.com > ... > Grand Caravan > 2008 Dodge Grand Caravan

Feb 22, 2011 - ... do something with a misfire in the #5 cylinder of my V6 4.0L engine. ... ODB Code P0305- Misfire in #5 Cylinder on 2008 Dodge Grand Caravan .... My2005 dodge grand caravan jerks when it shifts into gear what could it be.

My Dodge Grand Caravan has a Cylinder 5 Misfire,? ' Yahoo An

posible bad belt or cranck gear

P0205 Dodge Injector Circuit Malfunction Cylinder 5 PCM !

You always disconnect the negative first to prevent arcing to the body.

http://www.2carpros.com/trouble_codes/trouble-code-P0100-P0199.htm
Here is a link where you can see what the codes mean.Hope this helps and good luck.

po123-tps curcuit high---po138-02 sensor high volts bank 1 sensor 2,--po205--injector curcuit open cylinder 5,---po305-- misfire cylinder 5,--po300 random/multible mis fire,

CODE 27 - Injector Control Circuit, output driver does not respond properly to the control signal

Code 27 MIL light options: OBDII
P0201 - Injector #1 Control Circuit
P0202 - Injector #2 Control Circuit
P0203 - Injector #3 Control Circuit
P0204 - Injector #4 Control Circuit
P0205 - Injector #5 Control Circuit
P0206 - Injector #6 Control Circuit

CODE 43 - Cylinder Misfire, or Ignition Primary Circuit

CODE $# MIL options: OBDII
P0300 - Multiple Cylinder Misfire
P0301 - Cylinder #1 Misfire
P0302 - Cylinder #2 Misfire
P0303 - Cylinder #3 Misfire
P0304 - Cylinder #4 Misfire
P0305 - Cylinder #5 Misfire
P0306 - Cylinder #6 Misfire
P0351 - Ignition Coil #1 Primary Circuit
P0352 - Ignition Coil #2 Primary Circuit
P0353 - Ignition Coil #3 Primary Circuit

did you try to replace the crankshaft position sensor?

Multiple miss-fire and miss-fire on #5. I would first change the sparkplugs then replace the distributor cap and rotor. There is a good chance this will fix the problem, but no guarentees.

Hi...
The Code P0340 on your Stratus is :
Camshaft Position Sensor Loss signal.
Ok, The first step is check tha condittion on the connector.
For corrosion, bent pins or damaged wires.
If you found that everything is ok.
Replace the Cam Position Sensor.
The Cam Position Sensor, Is common that the Cam fail on this Vehicle and similars of this.
Tha Cam position sensor Is located:
At end of the engine head, driver side. Is attached with 4, 10mm
screw, and the connector at the center of the sensor.

I hope this help on your problem.
Thank you for use fixya...