Under the rear wheel wells, along the edge near the back is a screw. There is one on mine but there be more than one. Remove the screws for each.
After this, pop the rear trunk and look along the edge of the trunk right where the trunk hood meets the trunk itself. There are three black plastic screws that hold the rest of the rear bumper to the frame. I don't know exactly how these screws work but they don't just unscrew - I had to pop them out with a screw driver instead of rotating them out. Once those are out the rear bumper will lift up and off. There are some hooks along the rear wheel well where you removed the screws - you need to lift and pull out these edges, then lift the entire rear bumper off from the middle of the rear bumper.
Once you've done this, it goes pretty easily. If you have no problem with removing the black plastic screws or unhooking the edges, it should come off in less than five minutes.
Read more: http://wiki.answers.com/Q/How_do_you_remove_1996_Honda_Accord_rear_bumper#ixzz1Azw2wVAN
SOURCE: 2005 Honda Accord Front Bumper cover replacement
easy there is a screw on both sides were bumper and fender meet just pop back fender liner its a phillips head. Then pop hood remove clips on black trim infont of radiator. Underside where bumper goes under car remove those clips and 10mm bolts after all is removed bumper just pulls off ...... may have to give it a hard **** a few times but it will come off. Should only take 15-20min to remove if its your first time
SOURCE: Bumper cover removal
It is a little more complicated than that. There are two nuts below the headlight assemblies in the engine compartment. You will need to remove the battery and overflow bottle to get at the one on the passenger side. Remove the turn signals in the bumper, then there are 2 or 3 bolts holding a mounting bracket behind the each of the turn signals. There are a number of bolts with washer heads and reatiners on the underside of the bumper as the previous responder indicated.
SOURCE: Need to remove bumper of 2000 Honda Accord Coupe
i think there just bulbs unless u have damage and your replacing .i have a 98 also owned 92,94 i just started removing bolts attached to bumper but putting on a little tougher start one top center bolt then do the one on each sidein wheel wells to fit it in there ask someone to help hold while your bolting then do rest of bolts wamo bamo....
SOURCE: cant remove the tail light assemblies on '09 accord sedan
youll have to pull up very firmly or it may have to slide to the side its held in place by a bodyfastener. a screw that fits into a slot. but i would try pulling up first.
1,756 views
Usually answered in minutes!
×