It is located on top of the heater box in the passenger side remove the glove box to gain acess there are two 7mm srews and a relay braket holding it in place it is a tight squeeze but can be removed with a 1/4 inch ratchet.
source: fixya
thanks for using fixya
Hope this helps
Blower Motor Resistor
Removal & Installation
To Remove:
Disconnect the negative battery cable.
Remove the glove compartment door.
Remove the plenum tray.
Disconnect the electrical connector.
Remove the blower motor resistor mounting screws and remove the resistor.
(Front blower motor resistor removal/installation)
To Install:
CAUTION
Do not bend the resistor coils or allow them to touch each other.
Install the resistor in the plenum.
Tighten the mounting screws to 12 in. lbs. (1.4 Nm).
Connect the electrical connector to the resistor assembly.
Install the plenum tray.
Install the glove compartment door.
Connect the negative battery cable.
Check the operation of the blower motor at all speeds.
SOURCE: blower motor resistor location on a 1996 gmc 1500?
It is located on top of the heater box in the passenger side remove the glove box to gain acess there are two 7mm srews and a relay braket holding it in place it is a tight squeeze but can be removed with a 1/4 inch ratchet.
SOURCE: 1996 GMC Sierra Heater blower motor only works on
The blower motor resistor is located within a foot of the blower motor in the duct that the blower motor blows into. The resistor is actually cooled off by the blower motor blowing across it. It has a wire harness that connects it to motor & fan switch. It is held in place by 2-4 retaining screws. Disconnect wire harness,unscrew retaining screws then lift out. Reverse order to install.
751 views
Usually answered in minutes!
×