I would check your local junk yard
Shop is FULL of it!! That switch pulls right up with the use of a small flatblade screwdriver. Takes about 5 minutes to pull straight up and out, does have tabs to push in, be careful. Do it yourself, for $20 or less. Your shop was quoting you to replace the entire multifunction switch with the hazard light included. Quite a bit of work to get the harness out, but MUCH cheaper just to pull the hazzard switch out itself.
Get the unit from a wreckers /junk yard for a 1/4 of the price
SOURCE: brake light on 2001 chevy blazer LT 2wd
When my blazer did this they had to replace part of the wiring harness in the steering wheel. It took forever for them to get the parts because we live in nowhereville, but once it was in it works again and no problems. I had to take it to the actual chevy dealer because none of the other places had a clue. good luck.
SOURCE: 2002 Workhorse chassis RV hazard flasher doesn't work
I am looking for a locking gas cap for my 2005 Bounder 36Z. This motorhome has a Workhorse chassis. Can you help me locate the part number and a dealer near Newberg, Oregon?
Thank you.
Sharon Bladow
503 554-1281
SOURCE: hazard light switch
This is a rough one if youhave never taken apart the steering column before. the steering wheel has to come off and the air bags have to come off also. it would be easier to ttake it to someone to fix this
SOURCE: 97 BLAZER BRAKE AND HAZARD LIGHTS DON'T WORK
did you check the fuses?
If so, then check the plug on the steering column....
197 views
Usually answered in minutes!
×