2007 Jeep Liberty Sport Logo

Related Topics:

A
Anonymous Posted on Jan 13, 2011

Hello, I went to start my 2007 jeep liberty and its completely dead, nothing will work not even lights, what might be causing this other than the battery? Thanks!

1 Answer

Anonymous

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

President:

An expert whose answer got voted for 500 times.

  • Master 844 Answers
  • Posted on Jan 13, 2011
Anonymous
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

President:

An expert whose answer got voted for 500 times.

Joined: Jan 02, 2011
Answers
844
Questions
1
Helped
270438
Points
2995

Check all connections, cables especially the positive cable.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2008 Jeep Liberty died instrument panel frozen. no power at all

then starter motor is dead, and is silent, and will not crank the engine at all(I GUESS)
correct?
starter dead is just 6 causes posted her 1000 times and 1million times if you googled why is my starter dead
again just for your causes.
yous said jump starts fail but no words at all is the starter motor dead silent.
I can push start my car but it has a manual transmission.
all IP cluster freeze when engine dies and goes to self test mode , glows lamps.
scan the PCM now and it tells you what failed with DTC error as you crank any dead engine.

causes
battery cables lugs loose or rusty cleanm em.
1:battery is bad, charger it up first or replace it if charging fails or load test fails (those are TOOLS)
2: fuse blown. to IGN switch (check all fuses if savvy)
3: IMMO lamp not unhappy, bad key, lost 2nd spare key? oops. but cuts spark and confuses many.
4: keyswitch bad ST pin failing and BAD.
5: PRNDL switch bad (a/t box) shift tO N=neutral and turn key to ST crank position, cured?
6: starter relay bad.
7: starter motor dead and bad.
8: all wires connecting all this up above bad (we use a volt meter) to find all these.

THE STARTER MOTOR CAN BE HOT-WIRED TESTED IN-SITU, AND TESTED KEYS IN POCKET SAFE.
POSTED VAST TIMES THIS) OR ASK HOW. OR GET THE CAR SERVICED, BY FOLKS THAT KNOW HOW.
SKILLS AND TOOLS BOTH. YOU DO NOT HAVE.

TURNS OVER(EEKS)
50% OF POSTERS MEANS STARTER IS DEAD."NOT TURN OVER"
50% OF POSTERS USE THE WORD FOR ENGINE RUNS OR NOT. (CRAZY NO?) THIS USELESS PHRASE?
BEST IS SAY CRANK AND AVOID THE SILLY WORDS TURNS OVER.

CRANKS AND WILL NOT START (50 CAUSES)
OR WILL NOT CRANK (SURE IT CANT START)AND 6 CAUSES, BUT MINE PUSH STARTS ANY DAY.

IF THE STARTER MOTOR IS SILENT SAY SO
OR SAY IT CLICKS ONLY OR CHATTERS ONLY.
THE DEAF HELPERS CAN NOT HEAR YOUR STARTER , EVER. UNLESS VIDEO OF IT POSTED WOW..
0helpful
1answer

Had error message "gate". After opening and closing my rear gate,(2010 Jeep Liberty), interior lights went on. Made it to work. Tried to start car after work and the battery was dead.

scan it.
the CEL lamp on running means. "SCAN ME.," now.

the gate warning means just that, gate in ALarm.
and needs to be repaired.
0helpful
1answer

What caused my 2010 jeep liberty to go dark and dead?

You may have activated the anti theft device ! You need to use the key fob to lock and unlock the vehicle ! Then try it ! If no luck try You Tube !
0helpful
1answer

2007 jeep liberty suddenly won't start after

Try starting in neutral. Gear sensor may be heating up and not registering park.
0helpful
1answer

I started my 2002 jeep overland today in the morning and everything was fine. Drove to the gas station got gas went to start it nothing. No sound no lights just completely dead. I waited a few seconds and...

I would first clean the battery post and clamps, as a bad connection can cause a vehicle to act like the battery is dead, you can either buy battery terminal cleaner( it comes in a spray can) or you can use coke and a wire brush. Hope this helped Tim
0helpful
1answer

Lose belt on Jeep Liberty 2007 4x2 3.7L V6.

Most Jeeps use the power steering pump to adjust belt tension. there is a slide bracket at the bottom and a pivot bolt on top. adjustment is made by tightening a bolt at the end of the lower bracket. I have also seen this arrangement used on an idler pulley right below the pump but I may be thinking of some other vehicle.
0helpful
1answer

2001 grand cherokee ltd completely lost power

Check the connections at the battery. Be sure they're clean and tight.
Not finding what you are looking for?

237 views

Ask a Question

Usually answered in minutes!

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...