SOURCE: problems with clutch master cylinder on a suzuki
I too am having problems with my 2006 GV clutch master cylinder. I noticed gradually over several weeks the gears and clutch pedal were degenerating and then the cluth gave completely. My mechanic took a look around and said the cylinder is the cheapest one he has ever seen, it's just a piece of plastic apparently! Is going to hopefully get the part this week or next, though he said as it's such a cheap and nasty part its likely it will happen again in the future. Not happy!
SOURCE: mazda rx 7 rebuilt kit clutch master cylinder.
crack the bleeder nipple on the slave cyl and get some one to slowly push the pedal see if any fluid shoots out if not you may have killed the new seal in the master cyl.
it sounds like you did every thing right its just that old cylinders get were in them and if you don't hone them out and put a new sleeve in them quite often you will rip the new seal apart on the first pump of the pedal.
any way check for presser and let me no
SOURCE: ford focus st170 clutch master cylinder
To replace the clutch master, you must remove the under hood fuse box and air filter housing assm, then remove the hydraulic line that goes into the inlet port of the clutch master, then inside the car, remove the hush panel/knee bolster panel from under the steering column, and loosen the boilts that retain the brake pedal to the firewall, then remove the two 10mm bolts that secure the clutch master to the brake pedal assm. Reverse procedure ti install, then fill the brake master cylinder with clean fluid, loosen the bleeder screw at the top of the trans, and bleed the clutch as you would the regular brake system, but never pump the pedal, tighten screw, with foot off of clutch pedal open screw and press pedal to floor, then tighten screw before you release pedal, then release pedal loosen screw, etc. until no more air comes out, it may take quite a few times to fully bleed the system.
SOURCE: remove master clutch cylinder on 1992 bmw 325i
Perhaps this link will be of some help.
http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528004a3c7
SOURCE: how do i bleed the master clutch cylinder system on a 1995 jeep ?
A special pump is used to back bleed the system. If you don't own one then you have to be patient and just keep pumping the clutch pedal until it comes back. It can take a half hour to get it back. Just depents on how much air is inside.
478 views
Usually answered in minutes!
×