Wiper fuse location - Ranger Ford Cars & Trucks

The fuses for the wipers in a 2007 VW Rabbit are located in the fuse box under the dashboard on the driver's side of the vehicle. To access the fuse box, open the driver's door and locate the removable plastic cover on the side of the dashboard.

To identify the correct fuses for the wipers, refer to the owner's manual or the diagram on the underside of the fuse box cover. The wiper fuse will typically be labeled as "Wiper" or "Windshield Wiper."

Once you have located the correct fuse, use a fuse puller or needle-nose pliers to remove it from the fuse box. Check the fuse for any signs of damage, such as a broken filament or a blackened appearance. If the fuse is damaged, replace it with a new fuse of the same amperage rating.

After replacing the fuse, test the wipers to ensure they are functioning properly. If the problem persists, it may indicate a more serious electrical issue, and it is recommended that you have the vehicle inspected by a qualified mechanic

The windshield wiper relay on a 2004 Ford F-550 is typically located in the fuse box under the hood. The fuse box is usually located near the front of the vehicle, on the driver's side. To find the windshield wiper relay, you will need to refer to your vehicle's owner's manual or a wiring diagram for the vehicle. The owner's manual should have a diagram of the fuse box that will show you the location of the windshield wiper relay. Alternatively, you can search online for a wiring diagram for your vehicle.

Once you have located the fuse box, you may need to remove a cover to access the fuses and relays. Look for a fuse or relay labeled "wiper" or "wiper relay" to find the windshield wiper relay. If you are having trouble finding the windshield wiper relay, you may want to consider consulting a mechanic or taking your vehicle to a dealership for assistance.

The wiper fuse for a 2015 Mitsubishi Mirage is located in the passenger compartment fuse box. The fuse box is located under the instrument panel on the left side, for left-hand drive cars. And on the right, for right-hand drive cars. The wiper fuse is labeled "WIPER" or "WINDSHIELD WIPER". It is a 15 amp fuse. To replace the wiper fuse, you will need a small flathead screwdriver. Open the fuse box cover. Locate the wiper fuse. Use the screwdriver to pry the wiper fuse out of the fuse socket. Install the new wiper fuse into the fuse socket. Close the fuse box cover. If your windshield wipers are not working, it is possible that the wiper fuse is blown. You can check the wiper fuse by looking at it. If the metal strip in the center of the fuse is broken, then the fuse is blown and needs to be replaced. You can also check the wiper fuse by using a multimeter. Set the multimeter to the "ohms" setting. Touch the positive lead of the multimeter to the metal strip on one end of the fuse. Touch the negative lead of the multimeter to the metal strip on the other end of the fuse. If the multimeter reads "0 ohms", then the fuse is good. If the multimeter reads "OL", then the fuse is blown and needs to be replaced. Once you have replaced the wiper fuse, your windshield wipers should start working again.

What year ? The relay's are located in the under hood fuse box .
With the ignition in the ON position, accessory voltage is supplied through the 25A WPR fuse to the WIPER relay, the WIPER HI relay and the WSH relay that are all located in the underhood fuse block. Refer to Wiper/Washer Schematics. Which wipers are you talking about ? Front or rear . Rear wiper fuse is in the I/P instrument panel fuse box .
Fuse Block - I/P
Under the lower right side of the instrument panel

The wiper relay in a Pontiac Vibe is located in the under hood fuse box. With the ignition in the ON position, accessory voltage is supplied through the 25A WPR fuse to the WIPER relay, the WIPER HI relay and the WSH relay that are all located in the underhood fuse block.

There is a 30 amp (pink) fuse located in the fuse box located inside the car (see picture below) and it is in the number 11 position in that box. That fuse is for the wiper system there is also a hi/low wiper relay located in the power distribution box located in the engine compartment. It is in the number 1 position (the big number 1 not the diode or fuse). You may want to check that out as well if the fuse is good. The picture for that is also below. I hope this helped and good luck.

There is also a fuse module located on the passenger side of the center console under the dash. You can pull the plastic cover panel off by hand. This should be where the wiper motor fuse is located.

Locate fuse panel usually located in glove compartment or in drivers knee area.Once you have located your fuse panel see lid or panel it's self usually marked and numbered you will see wipers be sure when you remove this wiper fuse replace it with the amp type.

Yes its possible that the fuse is blown, check the fuse box and locate the wiper fuse and see if its blown if its blown replace the fuse with the SAME amperage rating, if its not locate the wiper motor under the hood on the firewall and unplug the connector use a test light and turn your wipers on from the wiper switch on your steering column if the test light lights you have power there and the wiper motor is probably bad if theres no power there but the fuse is good you have a broken wire and you need to check all related wiring from the wiper motor to the switch......

The fuse for the wipers on a 97 wrangler are located behind glove box just unhook strap that holds up glove box and replace.