I have a 2002 RSX Type-S and last night I was slowing down for an accident on the interstate and when I tapped the brakes i got sideways and spun around on slushy pavement. My car obviously stalled out and when I went to pull off the service engine and transmission light came on. I pulled the code up and it was P0336 Crankshaft Position Sensor. On the way home the car felt like it was going to stall out. Any advice on what the problem could be?

SOURCE: RSX type S transmission problem

This link will be helpful to you and checking the clutch and replacing it and laso you can find there the step to check also your transmission http://www.autozone.com/az/cds/en_us/0900823d/80/05/00/16/0900823d80050016/repairInfoPages.htm

Hope that helps.........

Marvin

• 85242 Answers
• Posted on Dec 22, 2008

SOURCE: MIL light on

P0139 Secondary Heated Oxygen Sensor (Secondary HO2S) (Sensor 2) Slow Response This is the Catalytic Converter efficiency monitor, it is reporting that the Cat Conv is not working as it should (cleaning up the exhaust), how many miles on the car?

SOURCE: Check engine light on a 2002 Acura RSX

Just hit the reset button, i have a 03 Civic Si same motor as base RSX mine came on everytime when i kept disconnecting the plug, never came back on. (i have a short ram intake)

SOURCE: 2003 Acura TL 3.2 61,000 transmission

I doubt they did anymore damage but i`ll bet that the engine was damaged from the training going out such as valve guides and seals and carbon build up on plugs ETC.

SOURCE: 2001 Acura MDX Stalling.

you may want to check the ground wire for the engine; if the car just shut down it's possibly an electrical. if the ends are corroded replace.