2007 chrysler pacifica cruise control not working

question edited for clarity.
Question moved to model category.

No, it just has the Integrated Power Module in the engine bay.

Chrysler Pacifica (CS; 2004-2008) fuses

Fuse-Box.info https://fuse-box.info > chrysler > chrysler-pacifica-cs-...

In this article, you will find fuse box diagrams of Chrysler Pacifica 2004, 2005, 2006, 2007 and 2008, get information about the location of the fuse panels ...

• 
  

  Fuse Box Diagram Chrysler

  https://fuse-box.info > Home > Chrysler
  Fuse box diagram (location and assignment of electrical fuses) for Chrysler 300 / 300C (Mk1/LX; 2005, 2006, 2007, 2008, 2009, 2010).

Chrysler Pacifica (crossover) (2003-2007) fuse box ...

imgVEHICLE.com https://imgvehicle.com > chrysler > fuse-box

An Integrated Power Module is located in the engine compartment near the battery. This center contains maxi fuses, mini fuses and relays. A label that ...

Chrysler Pacifica 2005 Fuse Box/Block Circuit Breaker ...

CarFuseBox https://www.carfusebox.com > chrysler-pacifica-2005-fu...

Apr 6, 2022 - Chrysler Pacifica 2005 Fuse Box/Block Circuit Breaker Diagram ; 2, C51 18LB/BR, Fused Rear Booster Fan Relay Output ; 3, W4 12BR/OR, Front

..

Here is your fuse box diagram Annie, but the blinkers are not in it, because they are controlled by the Body Control Module. (BCM).

If the front is working okay, check the bulb connections, any wire connectors you can see and the wires in that rear area that go to the body for grounding.

You probably going to need a good auto-electrician.

Fuse Box Diagram Chrysler Pacifica (CS; 2004-2008)

https://fuse-box.info > chrysler > chrysler-pacifica-cs-2...
Fuse box location ... An Integrated Power Module (IPM) is located in the engine compartment near the battery. ... This center contains maxi fuses, mini fuses and ...

• 
  

  Fuse Box Diagram Chrysler

  https://fuse-box.info > Home > Chrysler
  Fuse box diagrams (location and assignment of electrical fuses and relays) Chrysler. ... fuses) for Chrysler Pacifica (CS; 2004, 2005, 2006, 2007, 2008).
  
  ..

https://www.moparfactoryparts.com/v-2007-chrysler-pacifica--touring--4-0l-v6-gas/fuel--fuel-lines

https://www.moparpartsgiant.com/parts-list/2007-chrysler-pacifica/fuel/fuel_line.html

https://www.jeepwarehousedirect.com/v-2007-chrysler-pacifica--touring--4-0l-v6-gas/fuel--fuel-lines

Start with cleaning the throttle body and idle air control motor. Check and replace air filter if needed.

Hi Daniel, I'm glad to help! One of the most found problems with cruise control's inoperative here at the dealership is a vacuum problem. If you do not have vacuum from the engine to the cruise control under the hood, then even though the rest of the system is working fine it will not pull the accelerator pedal. NEXT: Another problem could be that the cruise control unit under the hood is not getting power from the brake switch. Check and see if there is power at the unit's connector under the hood. If there is no power then replace the brake switch. NEXT: The PCM may not be getting a signal to apply the cruise and this mainly happens because of a cruise switch problem OR the signal is not getting through the "Clock Spring". This could be either one causing this problem, so replace the switch first because its cheaper. If all of these things check out good then it could be the Cruise Control Unit itself. Hope this helps and have an awesome day Daniel.

Could be one of your wheel speed sensors is out. The ABS and traction control are linked on most vehicles so when the sensor is bad it will disable the traction control. The best thing to do would be to get it scanned and see what code the computer is throwing.

Some of these dont use a light you just hit the on button and set cruise remember if brake is hit it shuts down and you must be going over 40mph, if this doesnt work then check your fuses,good luck.

AWD Clutch Power Control Circuit Low

Yes. They're there for courtesy.

There is no cruise relay