SOURCE: Vacuum diagram of Mercedes 190D, 2,2
neto 190D: You are asking about a vacuum diaphragm?
I'm going to take a WAG.. Your engine won't shut
down with the key?
If so, he is the way you find out:
In your injection pump, the vacuum diaphragm which kills the engine is the one which has the fitting pointing parallel to the ground.
The vacuum line which serves it is a brown/blue
To check the system, first check for vacuum in the line. Run the engine for a minute or so. Cap off the brown/blue line.
Turn the ignition switch off and then with hose in hand, uncap it and you should hear a hissing sound. If you have a vacuum guage, obviously, use it for the test, you need a minimum of 10 inches to kill it.
To test the pump diaphragm, you can rig a vacuum line to a known vacuum source close to the main "T". Run the engine and with the line connected to the diaphragm, connect it to the good vacuum source, if it kill the engine, the diaphragm is good. If you have a hand vacuum pump it would be more ideal, because you could check the diaphragm for small leaks.
If the diaphragm is bad, it is easy to replace on the pump.
The shutoff diaphragm lists for $86.00
Is my shot in the dark correct?
Even though I am a Nissan Master tech, I also specialize in Mercedes-Benz and specifically Diesels, so if you need help, I'm here. I went through a few Mercedes Schools and have been swinging Iron in Mercedes since the 70's
I might be a little more informative than the public library.
SOURCE: remove the inside rear door panel for 1995 Landrover
Remove the 2 bolts holding the grab handle ( 10mm) Remove the screw holding the pull handle plastic cover and remove the cover. Use a fork and pry the panel away from the door and you will be able to pull it off. Before refitting, check all of the plastic clips that hold the panel to the door, some will have broken off. Remove them and fit them back on to the trim panel and glue them on. Refit is reverse as removal. Hope that helps
SOURCE: i need a diagram of the firing order for spark
2002 Land Rover Discovery II 4.0 liter V-8
Hope this helps (remember rated this).
VACUUM LINE DIAGRAMS
There
are few direct links showing exact vacuum line diagrams. I suggest you to refer
the direct links.
Click
the link below: -----
---------------
http://howtobyme.blogspot.in/2012/01/how-to-locate-vacuum-leak.html
-----------------
http://schematicsdiagram.blogspot.com/2011/12/vacuum-hose-routing-diagram-for-1995.html
------------
http://repairhelpcenter.blogspot.com/2011/11/vacuum-diagrams-for-audi-a4.html
--------------------
-------------
--------------
-------------
http://technoanswers.blogspot.com/2012/01/vacuum-diagram-for-isuzu.html
-------------
http://technoanswers.blogspot.in/2012/02/ford-4-wheel-drive-vacuum-solenoid.html
------------
These
will help.
Thanks.
53 views
Usually answered in minutes!
×