Please tell me how to reset the "Service Indicator" on 2005 MBZ ML 350. Thanks; Rass

not normally most mercs have a chain timing belt so dont need doing its only need replacing if its worn which in most cases you can here a rattle from the engine dont let any one tell you they need changing every so many thousand miles as this is rubbish mine has 176000 miles and still has originall chain hope this helps

Check the connector on side of trans, these are notorious for fluid seeping through the connector and going up harness and in to tcm, if tcm not contaminated replace connecter on trans then recheck... if the fluid is not contaminated it should cure the problem. if fluid is contaminated then it probably an internal problem.
Hope this helps.

MANY are connected to the drivers door lock, using the key , turn it to the left pause turn it to the right pause... do this twice...

Hi. Thanks for your question. For assizstance on EPS light in 2008 ML 350 You can visit https://www.reliable-store.com and download the entire workshop manual which includes all the information along with the diagrams which will help you in checking lights. Good day!

http://forums.mbworld.org/forums/m-class-w164/250094-clearing-maintenance-service-indicator.html

try the info found here

SERVICE B REPLACE CLEANER FILTER, INSPECT SERVICE BRAKE SYSTEM, REPLACE CABIN AIR FILTER, LUBRICATE DOOR HINGES AND LATCHES,REPLACE ENGINE OIL AND FILTER,INSPECT SERVICE EXTERIOR LAMPS, READ CLEAR FAULT CODES, TOP OFF FLUID LEVELS,LUBRICATE HOOD LOCKS, INSPECT SERVICE INTERIOR SWITCHES,INSPECT ADJUST PARKING BRAKE,RESET SERVICE INDICATOR LIGHT,INSPECT SERVICE STEERING AND SUSPENSION, LUBRICATE SUNROOF GLIDES,INSPECT ADJUST TIRES AIR PRESSURE,ADJUST LUBRICATE THROTTLE LINKAGE,REPLACE WINDSHIELD WIPERS.NOW 60000 MILES INTERVALS YOU NEED FLUSH BRAKE FLUID,FLUSH COOLANT,REPLACE FUEL FILTER,REPLACE POWER STEERING FLUID,REPLACE SPARK PLUGS,REPLACE TRANSMISSION FLUID AND FILTER.

It's an yellow warning indicator lamp. It lights when brake pads are weared. Now it's time to replace the used brake pads!

hello

you could try unpluggin the negative battery cable from your battery for five minutes so it resets the computer

http://forum.chryslerminivan.net/printthread.php?t=113 visit yhis site it may help you