2000 Buick Regal Logo
Posted on Jul 09, 2008

Insterment panel light out.

I have replaced the fuse inside the car for the cluster 3 times today and the insterment panel light will not come on when I turn on my headlights or parking light

  • Anonymous Mar 13, 2014

    insterment cluster light don't work

×

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

Mayor:

An expert whose answer got voted for 2 times.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 6 Answers
  • Posted on Nov 01, 2008
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Mayor:

An expert whose answer got voted for 2 times.

Problem Solver:

An expert who has answered 5 questions.

Joined: Nov 01, 2008
Answers
6
Questions
0
Helped
2250
Points
8

When you say you replace the fuse 3 times, is because the fuse have blown? If so, there is a short in the system and will need expert help to trace the short.
Does the day time running light stay on during day light hours and does the lights comes on without activating the headlight switch during night hours when the park brake is released?
If so, this of course is normal condition. If not then the day time running light circuit needs diagnosing along with the body module circuit. Headlight switch will also need to be tested.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have a 2003 plymouth voyager p0700-p0755,came up have no curent to speed senser-check eng.light,blinker's or insterment cluster

If you are saying the instrument cluster is not working correctly, you need to check the fuse and the power circuit to the cluster.
Looking at the wiring diagram, I don't see any power going to the speed sensor, so I think it generates its own signal back to the trans control module.
The trans control module gets power from a trans control relay and a 20amp fuse.
0helpful
1answer

2003 mercedes e500 brake lining light in insterment cluster how do i reset it

If the brake wear light on you can't reset the light without replace brake pads and sensors inside the pads must replace both after replace it will off automatically
4helpful
1answer

Installing Dash light bulbs in a 1993 S-10 Blazer

To replace the blubs you have to take out the insterment cluster. This is done by romoving the light switch trim plate and disconnect the wirering harness. The remove the A/C heater control panel. Remove the plastic trim from around the insterment cluster. The unbolt and remove the insterment cluster and uplug the wires and the speedometer cable. This speedometer cables can be a pain in the **** but depress the spring clip and pull. The bulbs are accessed from the back of the cluster.
Bulbs in this cluster don't burn out very often and if none of the bulbs don't work it probley isn't the bulbs. In this cause make sure the dimmer switch is turned up if it is play with the switch see if the dash light flicker.
Oh also in the mauals they always tell you to disconnect battery when pulling electrial apart.
0helpful
1answer

The insterment panel and rear parking lights went out

I have same problem. Fuses keep blowing in 1 to 2 days, which affect all interior & instrument cluster, parking/tail/turn signal, Lights which was 4 fuses. Good Luck & def. check fuses (3 locations)
0helpful
1answer

Lite does not work for ashtray and for the insterment cluster that is attached to headliner that tells u temp and north or west how can i fix it thanks

there will be a fuse panel on the inside of van on driverside under dash,pull open cover and look inside cover for proper fuse, if u have a test light check for blown fuse. hope this will help!!!
0helpful
1answer

I would like to know where I can find the (on board computer). I lost my insterment cluster and turn signals. I tried removing the (iod) fuse but that didn't work.

u have all the fuses in the fuse panel under the hood,they are marked for everything. use a test light to find the blown fuses and replace them. tail light fuses are 15amp
8helpful
3answers

The light behind my odometer in my 2003 buick century has gone out. I replaced the cluster fuse 10A but this did not correct the problem. Am I changing the right fuse?

yes but if the fuse is not bad then it is a blown bulb. pull the insterment panel aff dash and locat the blown light. replace and have fun
0helpful
1answer

Every once and a while my moms lincoln continetal starts beeping

somthing has gone rong with the insterment cluster. if all gages are working then i would just ignore it cause the insterment cluster is really pricey plus alot of labor to replace
0helpful
1answer

Dashboard lights going out

thare are 5 illumonation bulbs in the back of the insterment cluster . the insterment cluster has to be removed to replace these lights - not an easy job- not a do it yourselfer. i did one at the job the oter day and i think the charge was around 300 dollars for labor and the bulbs are 80 cents a piece- if you have someone do the work make sure thay replace all 5 illumination bulbs while thare in thare blown or not
0helpful
1answer

The insterment lights don't work

I know this might sound strange to you, but check the TAILIGHT fuse. Some GM cars suffer similar symptoms. Tailight fuse blows ( tailights inop and unknown to the driver ), and sort of like a warning of something wrong, NO DASH LIGHTS. Check this first. You still might have other probs
Not finding what you are looking for?

362 views

Ask a Question

Usually answered in minutes!

Top Buick Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...