Looks like not enough fuel pressure, check the fuel filter.
and the fuel pump pressure.with car running 60 psi
the pump is located at the rear seat driver side you have to remove the carpet to access the cover. if the fuel pressure checked "OK" suspect defective maf sensor (sometimes defective maf sensor do not show errors codes)another way to test is disconecting the maf sensor and start the car (computer goes to limp in mode) and works little better,or check by scanner idle= low grams per seconds and increase when accelerate.
SOURCE: how to put gear stick into neutral on mazda 323 without coded key
hot wire the car this will bring the ignition lights on then you can put it into neutral
SOURCE: replacing neutral safety switch on 2000 mazda mpv
ALLData.com probably has the best info for your MPV. I use it for my 2000 MPV and it hasn't failed me yet. Mazda wants $250 for a shop manual and Haynes hasn't written one as of yet. My MPV right now won't come out of 2nd gear because of (I'm hoping) a bad PRNDL Range Select Switch.
SOURCE: where is the location neutral safety switch on
2001 Mazda Truck MPV 2WD 2.5L
MFI 6cyl
The neutral saftey switch is on the front of trans. To remove, unscrew the four
screws that hold up the plastic cover, remove it then look at front of
tran it will be right there.it will have the shifter cable attatached to
it. Loosen the bolt an make shure to put the van in nuetral there will
be a small hole at the top of the shifting nob put a small brill bit
through the hole an through the saftey switch this will aline the two
an should start.
Good luck (remember rated this post).
SOURCE: Mazda 2000 mpv will not start in park but will
The most likely cause is a bad neutral safety switch. It should be on top of the transmission. Follow the shifter cable through the firewall and the switch will be near the end of the cable
331 views
Usually answered in minutes!
×