Srs what does it mean when the srs light comes on?

SRS stands for Supplemental Restraint System. If this warning light stays on in your Mercedes Benz, that means that there is a problem with the airbags or the components that are part of the SRS system

It is for the Airbag supplemental restraint system (SRS.)

This is a air bag fault light .it comes on when you have a fault in the air bag system.

SRS is supplemental restraint system, meaning air bags, and seatbelts. You need to get is scanned to see what issue it has.

SRS stands for Supplemetal Restraint System. It is your airbags. If the warning light has come on that means your Airbag system has a fault. It is never recommended for you to do your own air bag work unless you have the proper training. It is a life saving device and needs to be taken care of properly and promptly.

SRS lite means airbag system is not working if the lite is illuminated.

srs means secondary restraint system. e.g air bags and things like that. when it stays on for a few seconds its because it is doing a systems check. if the light stays on all the time then there is a problem. hope i helped.

I'm guessing you mean the SRS light, yes. When you have a bad battery the battery voltage can drop below 10 volts. The SRS unit detects this voltage loss and set a DTC (diagnostic trouble code) for an internal SRS unit failure. You have to erase the DTC memory. You'll need an SCS service connector tool (P/N 07PAZ-0010100) You can order one from your local honda dealer. Don't worry its not more than $10. Then you'll have to find the MES 2pin connector located in the upper right hand corner of the drivers underdash fuse box. It can be gray, green or yellow in color. 1.)Turn the ignition switch off. 2.)Unplug the MES connector from the fuse box and plug your SCS special tool into the MES connector. 3.) Turn the ignition switch on. 4.) The (red) SRS light in the dash will come on for 6 seconds and then go off. Remove the SCS tool from the MES (2P) connector within 4 sec. after the SRS light went off. 5.) The SRS light comes on again. Reconnect the SCS tool to the MES (2P) connector within 4 seconds after the SRS light came on. 6.) The SRS light goes off. Remove the SCS tool from the MES (2P) connector within 4 sec. 7.) The SRS light indicates that the memory is erased by blinking twice. 8.) Turn the ignition switch off and wait ten seconds. You may have to do this procedure a few time to get the steps correct. If this sounds to complicated I'm sure your local Honda dealer would be happy to reset the light for you for no charge. Just let them know that the battery was recently replaced and you think that the SRS light came on due to low battery voltage. -Hope this helps:)

tcs=Traction control system srs=Safety restraint system
check fuses, pull codes off of computer. take to dealer

Hey, The SRS mean " Suplement Restrain System"

Or Air Bag System.

If you have the SRS light, you have problem with the Air bag system. and need to take codes to see what happen or what is damaged.
Honda 2000 Accord come with a yellow connector behind of the Instrument panel fuse box. That is used to take manual codes from the SRS computer.. to see the problem.

I hope this respond your question,

Thank's