Hazard lights and signals dont work. fuses and bulbs are good

hi. see if it as a relay in the circuit. most car lighting these day have
relays. mines got loads. good luck

The parking lights should be on a different circuit from turn signals - hazard lights. The bulbs usually have two filaments, one for each circuit.
On most models there is a tail light fuse and relay that handles front and rear parking lights.

Lets start at the beginning.
The turn signals and brake lights use different fuses but both go thru the turn signal switch and use the same bulbs.
Have you checked the fuses for each circuit and does each switch have power in and out ?

you could try replacing the turn signal switch. they go out after awhile.

Hi, you need to replace your signal switch. Please tell me your model and year if you need instructions.

well u have two seprate problems the hazards and turn signals have a flasher that needs replacing if the fuse is good on the fuse box marked signals .and there is a brake light switch under the dash board near the brake pedal it has two wires on it check the wires make sure they are connected if so replace the brake light switch

Did you actually check the bulbs? I believe your brake lights, signal lights, hazards all use the same bulb for each side.

Your brake lights may be your brake switch just above your brake pedal.
The signals could be your electronic flasher module (EFM) located under the dash near the steering column.
Your hazards may be affected by the EFM, but not likely and the switch for your hazards may be faulty

short in main harness.. but first i would check all bulbs... by this i mean pull out each bulb look at base make sure the two contact on bottom base of bulb are not melted together... aslo look good inside bulb.. to make sure the two elements inside bulb are not shorted....don't forget to check the wires to the towing plug if have one

It is the switch. Some call it a combination switch. The lever that works the turn signals, may also work the wipers thats why its called a combo switch. If the work with the hazards, then that tells you that the fuse, wiring, bulbs are all good. Has to be the switch.

The turn signals run through the hazard switch, I have replaced hazard switches for this problem.