To remove the sensor:
If the crankshaft timing sensor or the camshaft reference sensor is removed, follow this procedure when the sensor is replaced:
Spacer on crankshaft timing sensor and camshaft position sensor.
SOURCE: crank shaft sensor? is this the same as cam shaft
no each one has its own job,
crank sensor is counting crank shaft rpms
cam sensor is counting cam shaft rpms
is there any lights coming on just as this is happening?
i think you should have the fuel pressure checked when it dies out,you need at least 50psi at fuel rail
SOURCE: crank shaft sensor
o.k... on the very botton of the engine... right above the harmonic balancer... better known as the crankshaft pully... it shold be just off to the side a little
SOURCE: CRANK SHAFT POSITION SENSOR 20002 NISSAN ALTIMA
1st, Nissan had a recall on Crank position sensors for 2002-2006 Altima's. Check with you dealer before you go doing any repairs. You may discover you can get your car repaired at no charge.
NHTSA Campaign ID number :O7V527000
Symptom: Erratic behavior. Stalling and no starts and very difficult to diagnose due to the time frame in which the component actually malfunctions. The warranty should not be limited to the original owner.
I would also need more specifics as to which engine you have so I might assist you in where the location of the sensor is. The Altima had a 4 and a 6 cyl engine offered that year.
SOURCE: Crank shaft position sensor
it should be behind the harmonic balancer at the driver side , front of the oil pan
227 views
Usually answered in minutes!
×