-
Jaguar Master
17,989 Answers
- Posted on Dec 31, 2010
Re: Thank you for your response , been going crazy...
Jaguar 2000-06 - Locks & Lock Systems
Power Door Locks - Removal & Installation
Door Lock Switch
Door Lock Diagnosis & Testing
-
Visually inspect the following:
Misaligned door(s), hood or luggage compartment lid
Door latches
Actuating rod
Exterior door handle
Interior door handle
Door lock cylinder
Cable
Luggage compartment lid exterior release switch
Fuse(s)
Wiring harness
Electrical connector
Door lock actuator
Remote transmitter batteries
Vehicle battery
Remote transmitter
Door lock switch
Front electronic module
-
If an obvious cause for an observed or reported concern is found,
correct the cause (if possible) before proceeding to the next step.
Door Lock Motor
Coupe And Convertible
-
Turn ignition key to position II.
-
Motor door glass to fully raised position.
-
Turn ignition key to position O.
-
Disconnect the negative battery cable.
-
Remove door casing for access.
-
Remove door water shedder.
-
Position PVC secondary water shedder for access.
-
Slacken and remove the door glass rear runner lower securing screws.
-
Reposition door glass rear runner. Mark the position of the glass rear runner upper securing screw.
-
Slacken and remove the upper securing screw and move the runner away from the glass.
-
Disconnect door handle and lock barrel (driver door only) operating rods from latch links.
-
Slacken and remove the three latch assembly securing screws and position latch for access.
-
Remove latch motor harness multiplug from mounting bracket and disconnect multiplug.
-
Release operating cable from door handle. Move inner door handle
to the locked position. Remove operating cable outer abutment from
support bracket. Disconnect cable inner from door inner handle.
-
Remove lock motor assembly from door.
-
To install, reverse removal procedure.
Fig. Removing door lock actuator
Sedan
-
Remove the door window glass
-
Detach the interior door handle.
-
Detach the actuator remote cable from the interior door handle.
-
Remove the interior door handle.
-
Detach the door window glass run.
-
Remove the exterior door handle retaining screws.
-
Remove the front door actuator retaining screws.
-
Reposition the front door actuator and exterior handle.
-
Remove the front door actuator and exterior handle.
-
Disconnect the front door actuator remote cable.
-
Detach the door lock cylinder connecting rod (1).
-
Detach the exterior door handle connecting rod (2).
-
Remove the front door actuator (3).
-
To install, reverse removal procedure.
Fig. Removing door lock motor-Sedan
Hope this helps.
×