I replaced defective starter on my 200 s10 pickup 2.2l, it did start up several times within 15 min,after driving 2 miles check engine light came on. when i turned off vehicle i immediately tried to start, but i have no check lights but the battery light on dash and nothing happens when i turn the key, i did find the obd code of p0113 and found out i forgot to connect wire to air intake

Kind of sounds like a power control module.

I have 94 s 10..4.3 v6. it does the same thing have replaced fuel pump and filter,ignition module,cap rotor plugs wires,coil,ground strap...driving down the road jus dies like the key got shut off....for a while when troubleshooting through the parts you could get it to restart.....now when it dies it cranks really hard when trying to restart..ive checked the timeing its fine....if i wait a few min it will usually start...sometimes it will show a check engine light sometimes not......never know when it will happen sometimes jus down the the road from the house sometimes 100miles down the road......sometimes three times in a mile sometimes not for weeks at a time..Wtf...Im ready to shoot it like a lame horse....its a shame too its a sharp lil truck thats a two owner and never spent a night outside in its life...i knew the original owner ...i bought it with 90,000 on it it only has 148,000 now and still looks like new...

Engine mounts do not go bad in five miles. Sounds like you're treating a symptom and not the cause of a more serious issue. Are you sure all cylinders are firing correctly? That the severe knocking is not coming from your engine internals? Have you checked the steel around the engine mounting points for cracks or other damage? And just in case, if the mounts you are using are poly, are you lubing them before installation?

check the compression in the cylinders.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/david_4c166ba81493f541

if it shuts off while driving and will not start back up for at least 10 minutes, then it may be the crank sensor doing this. is check engine light on! if so get it scanned to find problem code. if no scanner, auto-zone will scan for free. if light is on. CPS symtoms are: car dies and won't re-start till it cools down, or won't start at all. good-day ! crank sensor timing will be out of sync. it controls timing and sends info to pcm.

Try disconnecting the battery (unhook on of the terminals) wait for like 15 mins, hook the terminal once again and start the car. I also own a 2003 Jetta and once my engine light would come on after 2 mins of driving. Disconnecting the battery is like resetting the computer and hopefully the sensor.

starter drive probably bad can be replaced

I had to rebuild my engine at 97000 miles cuz of low engine oil pressure and bad berrings

I had a similar problem, do a compression check you may have a valve problem.

try replacing the egr valve,or the fuel filter or if throtle body injected try cleaning the presser regulater