SOURCE: removing the 2.7 engine from 2001 sebring sedan?
ok heres the simple version its alot of work
remove hood put someplace safe
disconnect all wireing and mark off with masking tape and marker
****** you need car lift ******
remove all plastic part molding from engine
find the engine hoist holes for chain to hook to
this is a unibodi design so the whole front chassis drops down
unbolt the chassis make sure to have the chasis blocked and stable
lift car while chasis stays on floor engine tranny and every thing inside hood comes down on the unibody this is how you remove an engine from a sebring
or you take to the dealer spend the doe cause you got a nice car and have it done right
SOURCE: driver side power window stopped working
The door panel is held on by plastic clips and 5 screws. 3 screws are on the bottom and 1 in the pull cup and 1 in the inner door handle.Then grab one of the corners and give a small tug, when you get some of the clips to pop out then proceed around the whole panel. To replace the panel take the clips out of the door with a fork and slide them back into the panel and then line it up on the door and use your hand like a hammer and bang the panel back on. Hope this helps
SOURCE: 2002 Chrysler Sebring Oil pressure light
Could be a bad oil pressure switch, or a bad oil pump. Both will cause this issue. Hope it is the switch b/c the oil pump is a costly repair.
SOURCE: no power to cigarette lighter, and no fuses
Did you check the fuses under the hood? The cigarette lighter fuse is not located in the fuse box by the passenger door.
SOURCE: replace air filter 2002 Chrysler Sebring convertible
you need to loosen the clamp on the throttle body and unplug the map sensor then there are two clips on the other end pull that out and you should be able to pull the filter out you don't need to take the box off.
174 views
Usually answered in minutes!
×