Fig. Ignition coil assembly mounting-3.0L DOHC engines
Removal & Installation
3.0L (VIN S) Engine
To install:
Ignition Coil Pack
Removal & Installation
2V Engine
To Remove:
To Install:
When removing the spark plug wires, a slight twisting motion will break the seal and ease removal.
4V Engine
To Remove:
how do I replace the ignition coil in my 2002 ford - cowlpic.gifclass="h_mi">Remove the RH cowl grille
When removing the spark plug wires a slight twisting motion will break the seal and ease removal.
Click on X's for diagrams.
Coil on Plug
The coil on plug (COP) ignition operates similar to standard coil pack ignition except each plug has one coil per plug. COP ignitions have three different modes of operation: engine crank, engine running, and CMP Failure Mode Effects Management (FMEM).
Engine Crank/Engine Running
During engine crank the PCM will fire two spark plugs simultaneously. Of the two plugs simultaneously fired one will be under compression the other will be on the exhaust stroke. Both plugs will fire until camshaft position is identified by a successful camshaft position sensor signal. Only one cylinder (under compression) will fire once camshaft position is identified.
CMP Failure Mode Effects Management
During CMP FMEM the COP ignition works the same as during engine crank. This allows the engine to operate without the PCM knowing if cylinder one is under compression or exhaust.
×
SOURCE: 2002 ford taurus fuse panel?
Here is the owners manual from the Ford web site, fuses are under ROAD SIDE EMERGENCIES
http://www.motorcraftservice.com/pubs/content/~WO2TAU/~MUS~LEN/41/02tauog4e.pdf
SOURCE: how to remove 2002 ford taurus radiator
Remove the rad support cover, remove the electric cooling fan and shroud, disconnect the tranny cooler lines, drain the cooling system, remove the upper and lower hoses, remove the rad brackets on top of the rad (one on each side), have someone hold the AC core out of the way and carefully slide the radiator up and out
SOURCE: ignition switch in a 1995 ford taurus
my 1995 taurus dont start i change the fual pump and filter also ignition control mod what else could it be
SOURCE: 2002 ford taurus wtaer pump
Removal & Installation
3.0L (2V)
To Remove:
To Install:
Water pump bolt torque sequence (3.0L (2V) engine)
1,502 views
Usually answered in minutes!
×