Honda civic on my deshboard yellow light isconstntly on, please let me know how to remove it. thank you

HONDA ILLUMINATION NOT WORKING * HOW TO FIX ...

? 3:24
https://www.youtube.com/watch?v=oOHwDWjmYWU
Feb 28, 2011 - Uploaded by vehix411
No lights,cant see the dash lights,bad bulb,how to change bulb clucter ... i have a 2001 honda civic i installed a new radio andmy cluster lights are ... I just bought the computer or (multiplexer whatever) for my 1997 accord because my back tail lights won't turn on but I ... Martin Nikolov 4 months ago (edited).

Removing a Honda Civic instrument cluster - YouTube

? 4:01
https://www.youtube.com/watch?v=kzp1VqdlmU0
Oct 28, 2012 - Uploaded by mike937739
George L 4 months ago ... I used it to fix my burnt out check engine light bulb in my 97 civic. ... I have no light on my dashboard I already replaced the fuse but still nothing? so I'm ....2005 Civic cluster in 1997 Civic working!

1997 Honda Civic Instrument Panel Lights Problem ...

? 1:26
https://www.youtube.com/watch?v=mYVt93Rao6g
Mar 26, 2013 - Uploaded by fockyoumang

What was your reset procedure? It should have been done with the yellow 2 pin check plug for SRS. The SRS system is isolated electrically from the rest of the vehicle systems, perhaps you got something loose under the dash while looking for the SRS plug, it is around a bunch of wiring. Also, if the light came on there is a failure. You should be getting the code read, it could be important. If the failure is a seat belt, they are covered by Honda on a lifetime warranty, at least in the USA. Did you check fuses in all the fuse boxes, under hood and under dash?

The SRS light can be caused by a faulty switch in the drivers seat belt. Make sure that the switch is functioning properly. The SRS lamp can be cleared by removing the yellow plug in the circuit board under the dash (just under the steering wheel). Here's a pretty good link to a repair. http://www.youtube.com/watch?v=PYYzt04o5MU The car in the video is newer that 2003 but the repair is the same. Good luck

The SRS light comes on when there is a fault detected with your seat belts. You will need to scan the SRS system to get the trouble codes. you will need a high end scan tool for this. Once you know the codes you will have a much better idea of what to do next.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Hi, look here: http://www.2carpros.com/diagrams/honda/civic/1998 and please let me know if you have any questions.

Thanks for using FixYa.

Welcome to Fixya

Here's the process on how to remove the dome light.

1. Carefully pry off the lens (A) with a small screwdriver.
2. Remove the two mounting screws.
3. Disconnect the 3P connector (B) from the housing (C).
4. Disconnect the 8P connector (D) from the ambient light (E).
5. Install the light in the reverse order of removal.

Thank you for using Fixya!

If you need further help, reach me via phone at https://www.6ya.com/expert/elixirjose_00375ea24bd8141b

Please see my tip at http://www.fixya.com/cars/r5932051-check_engine_light_check and let me know if you have questions.

Remove the panel covering the light from the inside of the trunk.Remove the nuts from the tail light studs and remove the light.Twist the socket to remove it and then put in your new bulbs.

you need to bring it somewhere to have a computer put on it to retrieve the code there is something wrong prob a sensor i dont know were you are but auto zone does this for free and can tell you what you need

The switches have to be removed and the bulbs are on the back of the switch. they look like a grey plastic screw. the bad news is that they are a dealer only item.