Electrical problem honda

1990 Honda Accord Workshop Repair Service Manual PDF Download

for the easy solution download the pdf file

You have a defective transmission pressure sensor.It's cheap to buy and not difficult to install.There are numerous tutorials on youtube

possible that clutch has failed, to test do following
switch off engine and put gear into 4th, with brakes on try to start
engine while in gear. if the engine starts switch it off straight away

this confirms your clutch has failed, if engine stalls your clutch is good.but could mean that the clutch activator is not working. either way
recomment you see a qualified dealer or machanic about this issue.

I hope this was helpful

Check your main relay. It powers the fuel pump and the ignition system. They are a known problem, with a high failure rate, on the 90-93 accords. I do believe it's worth checking.

What model and year honda do you have? If it's an accord, 90-93, take a look at your distributor by checking for spark, when the engine dies. If no spark, it's usually a bad distributor on those year accords.

without doing further testing it is difficult to say, but there is a part called the main relay, located under the dash on the drivers side. it controls the power to the fuel pump, and is a common failure on older hondas. good luck!

disconnect the heater supply pipes and put the hose through the heater pipes and the reverse the flow direction this should help .If it doesnt the put some caustic soda in the rad and run engine for till it gets hot then for a further 5 mins ,then flush it out again ,try it if it works then refill with antifreeze .use about 200grms of caustic soda

check your rear engine mount.

Delroy - Jamaica

how many liters is the engine on 92 honda accord ex? when i get up to about 45mph or somtimes 60mph the car jerks and then after that the check engine light comes on what could be the problem?

One common problem area is the ignition distributor. Another area to check is the electric fuel pump and filter. Is your warning light on for engine/PGM? If so, check for fault codes.