92 honda accord engine problem

If it isn't moving then it is NOT shifting into gear. The lever may shift up and down. But it does not mean the transmission is engaging. Might want to check your transmission fluid. I am assuming this is an automatic. Hopefully you didnt burn up your tranny.

First check the trans fluid (if its not a sealed transmission). They wont shift in gear if they are to low. If that is fine, The shift solenoid has most likley gone bad.

I suggest you have a transmission shop take a close look at your vehicle. That year accord with a v6 and automatic transmission had a recall for the transmission and your problem seems to be a slowly dying tranny.

check transmission fluid level- run/drive for about 10 min. , park car- check with engine running- add fluid if needed- ,if fluid NOT low- transmission filter needs to be changed

i had the same thing...It's the transmission. It's REALLY noticeable shifting from 1st to 2nd gear. I was able to get my transmission fixed for 900 bux. That wasn't even a replacement so i can imagine how much it would cost to get it replaced. The shifting will get worse. By the end of my "experience" it wouldn't shift from 1st to 2nd for about 5 minutes until i drove it around for a bit. THen it would "warm up" to the idea of shifting to 2nd gear.

that delayed reaction may be the transmission slipping. with those many miles it could be the transmission going bad

First thing to do,try to pump your clutch before you shift into 1st gear then if you feel makes better, most probably you have problem with your hydraulic clutch system, check the clutch line if there is an evidence of fluid leaking or it could be internal leak.

Second thing to do, check your transmission oil, may be it' s too old or you use a thick oil thats why when cold its hard to shift then when the engine rich the normal temperature(warm) the oil become thin and the shifting will smooth. Remember the very old oil become thicken and the purity is gone and can cause of hard shifting. in this regards i suggest you to change the transmission oil and check the used oil if there is small peace of metals, then you are in big trouble,

Is there a check engine light on at all?

Blinking light means there is a trouble code.There is a procedure to manually pull codes from the computer.Have the codes checked,have them written down.It could be just shift solenoids,or could even be something more serious,but thats the starting point.