When to change timing belt on 2003 mitsubishi galant

Hi Kevin, Mate I had a look on youtube and all those 2.4L motors are belt driven... The two youtube videos links below are of a 2003 Mitsubishi Galant 2.4L with a timing belt and the next is a Mitsubishi 2.4L sohc with a timing belt, I hope this helps.....CHEERS.

Part 2 2003 Mitsubishi Galant 2 4 Timing Belt Installation

How to Remove and Replace the Timing belt and Water Pump Mitsubishi 2 4L...

its behind the timing belt down by the crank pulley. Basically you will need to remove the timing belt in order to replace

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Timing belts should be changed at around 60,000 miles on engines with timing belts-especially on 'interference engines', which are engines that, when the belt breaks while the engine is running, will at least damage the valves and sometimes even pistons. You do not say what engine or model car your Mitsubishi engine is, but most Mitsubishi engines are interference engines. Better safe than sorry.

On the 2.4 and 3.6 liter engines it is behind the timing cover down by the crankshaft sprocket.
Caution: the timing belt cover bolts of varying lengths. Be sure to mark the bolts and the cover to return them to the proper holes.

You may wish to change timing belts while you are in there.

mitsi recon on 80k,(or when showing signs of wear).i always say 80 for nearly ALL cars,as who pays the bill when it snaps......?

yes change the timming belt before it cost u another engine when ur belt cuts

Should be on your 2nd timing belt. If you have the 4cyl engine there is a balance belt that needs to be changed also. Mitsubishi recomends replacement at every 60,000 miles, your 10k over. Most of the time these motors are not interferance engines, But I have seen a few that broke a belt at high rpm that did bent valves......

Generally oil change and filter. Check/clean/ replace air filter. Plugs and/or leads. The tricky one is the timing belt. If it hasn't been changed to your knowledge then change it.( garage ) Brake pads and discs. Change as required. Coolant levels.

Call auto zone or adavnce auto

how to change crankshaft position sensor