It will depend on whether yours is an OBD system or not. OBD (On Board Diagnostics), didn't start to become a legal requirement until 1996 but some companies were fitting them earlier than that. First check your steering column for the green style connector on the attached image. If there is none like that, use a torch and get your head into the Driver's side footwell. Your looking for the black style connector, (red circle), on the attached image. It will be at about the height of the driver's knees at the door side. They are sometimes tucked up under the dashboard, out of sight, possibly behind a small flap or cover.
I hope this helps.
SOURCE: how to retreive a check engine light from a 1991 subaru
read the info in the link it has a step by step http://legacycentral.org/library/literature/codes.htm
SOURCE: my 1991 Subaru Legacy won't go into gear
Does it go into gear ok when its not running? When its running does it grind when you try to put it in gear? Does clutch feel firm or soft when you push it in? If you can shift all gears when its not running then its a clutch problem. If you can't than its a transmission problem. Is it a hydrolic clutch or mechanical? I can only guess and i won't do that, i need this info to help you.
SOURCE: is 1998 subaru legacy a 16 pin OBD2 or do i need
Yes it is OBDII. Just a regular scanner is all you need. They run around $30 at most parts stores.
SOURCE: factory diagram for wiring a 1991 subaru legacy
http://www.powells.com/biblio?isbn=9781563926464
SOURCE: how to remove front axle of a 1991 subaru legacy
there is a roll pin which holds axle to trans remove this but be sure to put new axle in so you can see throught hole where pin goes it is not centered so axle can only go in one way or pin wont go back in
1,174 views
Usually answered in minutes!
subaru legacy 1991 model is showing engine check light but cant see obd port to do diagnostic. Anyone to help me?
×