Where is crank shaft position sensor located on 1997 jeep grand cherokee

Jeep Crank Sensor Replacement, P Codes P0351, P1391 ...

? 6:24
www.youtube.com/watch?v=7D0vUEDSwXo
May 12, 2013 - Uploaded by Robert DIY Replaced the crank sensor on this 2003 Jeep Grand Cherokee.... to replace my crankshaft position sensor on my 1998 grand cherokee laredo.

Jeep Crankshaft Position Sensor Replacement (CKP, CKPS ...

? 4:07
www.youtube.com/watch?v=1Ho5iAKQV00

Oct 27, 2013 - Uploaded by WeekendHandymen
hi , do you think if I replace crank sensor will solve the problem ,my jeep .... Where's the crankshaft located in 99 jeep grand Cherokee laredo .

No Crank Reference Signal at PCM No reference signal (crank-shaft position sensor) detected during engine cranking. Use this youtube step-by-step to fix it. How to diagnose P0320 crankshaft position sensor circuit failure

Jeeps have a problem with the crank shaft position sensor. It is located at the top of the transmission bellhousing on the passenger side. They go bad and a lot of times won;t set a code.Hope this helps please leave comment.

If your stateside the CPS is on the drivers side of the bell housing at approx 11 oclock.They have 1 or 2 bolts securing them.assuming its the 4 litre motor.If its right hand drive the CPS is on the fornt seat passengers side.

Typically it is located at the bottom of the engine near the harmonic balancer.

4.7L ENGINE CRANKSHAFT SENSOR LOCATED ON THE ENGINE BLOCK ABOVE THE STARTER. ON THE 4.0L ENGINE CRANKSHAFT SENSOR LOCATED TRANSMISSION BELL HOUSING AT THE LEFT REAR OF THE ENGINE. THE 5.2L 5.9L CRANKSHAFT SENSOR LOCATED ON THE ENGINE BLOCK BEHIND THE RIGHT CYLINDER HEAD.

Jeeps have a known problem of a crank shaft position sensor going bad. It's a sensor that works off rotation of the crank. to know where and what position it's in. The part is about $55 and it's located by the front of the transmission where it meets the engine block. Very easy to change. I've changed a few on Jeeps and they had the same problem with the Jeep shutting down going down the road. After a few days to 2 weeks it will go completely out and leave you stranded. So I" advise to get it fixed ASAP. "Crank Shaft Position Sensor"

my 1996 jeep grand cherokee lmtd. won't start did tune up. cranks but no fire. please help. engine code 54 shows up . cam shaft positioning no signal. . tested all circuit. changed cam shaft positioning sensor twice.still cranks did start once ran for 5 min. changed the sensor again. no luck. help please. keith

left rear of engine block,on transmission bell housing.best way from top under brake booster use a wrench,

I don't think the PCM is your problem, is the check engine light on? It could be you idle air control motor this is located on the throttle body, but because this happens while driving I am thinking you will need to replace your crank shaft position sensor it is located on the transmissinon bell housing it is very hard to replace without the correct tools. If the check engine light is on take it to a local auto parts store and ask if they can check the check engine codes for you they usally will do this for free.