The two brake lights will not come on but blinkers and hazards work just fine and so does the third brake light how can I fix this before dark???

I am unaware of what a "CO" display is.
Now with the blinkers, hazard, horn and brake lights not working that may be the multi funtion switch (blinker switch) that is located inside the column (where the blinker lever attaches).
Obviously the blinker, hazard and horn will all work off of something in the column. Brake lights, you may think a switch on the pedal.

the brake lights do work with that switch but when you have the kind of tail lights where a turn signal light shares the same bulb as a brake light, the brake light is cancelled for the turn signal by running through the multi function switch inside the column.
The third brake light does not blink so its not on that same circuit.

More than likley your multifunction/turn signal switch is bad.All the lights you are talking about are tied to this switch.

its not a fuse. grab the hazard button and try moving it, back, forward ect, it the hazards start to work, then replace the switch.

I would check the turn signal/ hazard flasher module, its on the brake pedal bracket, 5 wires, turn the hazards on and give the side of it a few raps with a screwdriver and see if it starts flashing. The PINK should have 12v. If that checks out good it may need the turn signal switch. At the turn signal switch there is a WHITE wire that should have 12v when the brake is depressed, then you should have 12 on the DARK GREEN and the YELLOW wires coming out. If the center high mounted light works, then the brake switch at the pedal is good.

I've worked on these the first drove me crazy. its the turn signal switch every thing runs thru these. head lights, turn signal, brakes. except the third brake light. it runs directly from the brake switch. go figuare

The hazard flasher is a separate flasher by itself for the directional has its own. The brake lights work off the brake light switch mounted by the brake pedal

check for the complete fuse box and search for short circuits. Check the fuses and the amps of each. Did you change the battery for a new one? Did you install any device not OEM? An alarm? Check the cable system. If this is ok, scan it.

check the bulbs again make sure the brake and signal light bulb has two filaments in it, the parking lights ony has one filament

YOU MIGHT WANT TO CHECK THE BULBS IN THE REAR LIGHTS THEY OFTEN STOP WORKING IF THERE IS A BURNT ONE . IF NOT THEN CHECK TO SEE IF YOU CAN HEAR THE CLICK WHEN YOU ENGAGE YOUR SIGNAL EACH WAY IT MIGHT BE IN THE STEERING COLOUM WHERE IT CONNECTS TO THE SIGNAL ARM

Turn signal switch 95% of t he time. Try to work your hazards, if it stuck at all will also cause this.