How to remove fuse panel from fuse block on 2007 toyota tacoma trying to replace 140 amp alt fuse

SOURCE: Removing the 100 amp fuse link in a 1994 toyota corolla

the fuse link is bolted in from the two side in the fusebox.you have to un bolt the whole fusebox so you can raise it and if you look at the sides there are two side panels that can be moved down so you can get a socket or spanner on the two bolts apprx 10mm. undo them and raise the fuse out and put the new one in and tighten up the bolts again. hope this helps.

SOURCE: removing the 8o amp main fuse from 1986 Toyota pickup

yes, you must remove the top panel on the fuse block the 80 amp fuse is bolted to the the fuse panel, hope this helps if not get back to me as i strive to be the best please rate my fix Thanks Ray

Mike Vincent

• 358 Answers
• Posted on May 20, 2009

SOURCE: 140 amp fuse blown request replacement instructions

you have to remove or access the bottom half of under hood fuse panel to remove bolts on teh bottom of that fuse.

SOURCE: How do you change the spark plugs on a 2007 Toyota Tacoma?

bring it to a garage

SOURCE: 2007 Rav4 120 amp ALT fuse, under the hood.

You should be able to unclip the fuse box and pull it up. then you can access the screw holding the fuse in place. Make sure to disconnect the battery first.