Inside or outside handle?
Installation Procedure
Interior handle access
SOURCE: door handle broken (rear left)
did you just break the handle or did you break it off from inside the door also? If it is only from the outside that is a much easier fix. Let me know what the issue is and I will try to help you as easy as possible.
SOURCE: How do you replce broken door handle?
This is a problem that you should be able to fix. With the interior door panel there are 3 screws. 2 in the arm rest and 1 on the door handle(opener), take those out. There is a C-clip on the window crank that needs to be removed. They make a cheap little tool to remove those but I've heard people using a shop rag and removing the c clip. To remove it, turn crank to around 9 oclock then slide the tool or rag behind the crank also coming from 9 oclock. Any position will work, my point being the tool must slide in from behind the crank handle. Use a flat head screwdriver to gently pry the edges of the door panel away. There are some little clips that pop loose. It's okay if some break you can buy more. After that you will slide the door handle (opener) forward a little to pop out. Twist and turn the panel to get it over the door handle. There are 2 bolts that hold the handle on from the inside. They are 10 mm. You can reach the most forward one pretty easy but the back one is taken out through a hole in the metal door panel. Mine had a sticker over the hole with a big yellow dot on it. After that it takes some pretty good force to get the handle out of the hole. Don't be afraid to push on it. When it pops out take some wire cutters and cut the little plastic clip that holds the metal rod to the handle. The lock twists out of the hole. Now this is when you need 3 hands. Hold the new handle close to the opening and twist the lock into position. Don't attach the metal rod yet. Now actually put your key in the lock. This helps you hold the lock in the correct position while inserting the handle. Put the top of the handle in first and then the bottom should snap in next. Now from the inside, reach up and slide metal rod in the hole and rotate the plastic clip to secure it. Now the hardest thing is getting that back bolt in. It helps again to leave the key in the lock and rotate it so the bolt can secure the locking mechanism to the handle. Put the front bolt in reinstall the interior door panel and you should be in business. Good Luck
SOURCE: Drivers Side Door Handle
You need to take inside door panel off This just clips on but there are screws in armrest and inside door handle look for any other small square covers that may hide screws Lift panel up Make sure window is up Disconnect wiring from panel and you can now get at door handle linkage and bolts
SOURCE: How to replace '96 Ford Explorer driver side exterior door handle
You will need to remove the door panel to gain access to the handle. Roll the window up or down as needed to get to the nuts that attach the handle to the door. You will also need to remove a rod the goes to the door lock. You will see the rod after the door panel is removed. Good luck.
SOURCE: how to replace front door handle on a 2001 toyota sienna van
We made a page with pictures and descriptions of this exact job.
Hope it helps.
http://www.findonefindall.com/toyota-sienna/siennadoorhandle.htm
All the Best
David
4,479 views
Usually answered in minutes!
Outside......chrome part of flip up handle swings freely with no action to open door.
×