How do we add cargo rails? We have a 2006 pacifica and we would like to attach some extra cargo on top in a car top carrier but we dont know how to do that

Hello, It could be a rocker arm or a weak hydraulic valve lifter. I would also check the oil level.

Check the heater fuse, if the fuse is ok then the element need to be replaced

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/tony_a41fa0b801734e2f

some models have an extra wire plug-in that would go to a light or temp controls on the very back of console. not all models have these options but all models have the extra plug-in. its cheaper for them to make one "fits all harness" than several different ones

Have to fabricate another frame to adapt the two.

I would say stainless steel or if you use aluminum
then have it anadized to prevent corrosion

I you don't weld or want to spend any money-- your done.

Each wheel has a sensor. Theres more to it than the sensors. have the repair shop check it over for you and recommend repairs.

INSIDE the tank. dont bother trying to replace it. When the fuel pump goes bad, then replace the whole module.

if you already removed the bolts that attach it to the spindle then you need a bigger hammer

PLEASE EMAIL ME AT YOUR CONVENIENCE

Dont know where your relay is but generally relays are grouped together in a box under the hood or on a rail on the firewall. They are "plug in" units that can be easily repalced.The ones housed in a box are usually easier to service because there is a description usually inside the cover. Many times the relays are the same# serving different purposes. If thats the case, use a good one and plug it into different slots 'till the fan comes on (make sure engine is hot enough for this to happen) Be aware that a bad sensor will give you a similar problem (it won't tell the relay to go on)