SOURCE: Replacing dashboard lights on an 2000 Oldsmobile Silhouette Van?
this will take some time but is fairly easy. you have to remove the dash pieces on that side. then this will allow you access to the instrument cluster. becareful not to wear clothing that will give off a static discharge this could short out the cluster board. the bulbs are tiny so be careful while rep-lacing them. the bulbs can be purchased at a local store the bulbs are a 194 or a 1893 in most cases.
SOURCE: drain the antifreeze on a oldsmobile silhouette
Under the bottom of the radiator on the there is a drain ****, you will have to raise the car and crawl under it to see it, be careful to not break it, the screw in plug is fragile, it will be hard to unscrew.
SOURCE: vehicle is overheating...2000 oldsmobile silhouette
It's possible you have a blown head gasket. In that case, the heater core which is above the engine fills with exhaust and stops working. To verify this condition, check exhaust for excessive white smoke. If leak is still small, it's possible you won't see much. In that case have a shop check the radiator for hydrocarbons (exhaust). If the test shows any in cooling system, you definitely have a head gasket problem.
I'd also check the thermostat. Sometimes it can give similar symptom but more often than not this will trace back to the hg.
SOURCE: how to install a oxygen sensor
There are usually two O2 sensors one on each side of the catalytic converter. Each has a wiring assemble and they are screwed into the exhaust system itself. You will need to have the engine exhaust cold as there is a risk of burn injury if it is not. Simply remove the old one usung the proper wrenches and disconnect the wiring at the connector. Reinstall the new sensor and reconnect the wiring at the connector. Make sure that the sensor is completely seated. If you have any questions please ask.
Thx
Deathstalker
SOURCE: How do I replace the fuel pump on a 2000
In order to replace the fuel pump on this vehicle you have to disconnect the battery, jack up the rear of the vehicle and support on stands. Support the fuel tank with a jack and board in order not to puncture it, loosen the fuel tank straps and lower the tank down enough to undo the fuel lines and plug in from the sending unit once removed lower tank down the rest of the way and change the pump. Put the vehicle back together in reverse order.
625 views
Usually answered in minutes!
×