Radio and navi won't turn on. Tried looking for blown fuse but unable to locate one. Help.

There are two fuse's , one is in the under hood fuse /relay center or as ford calls it Battery junction block and one in the central junction block Blown fuse(s): Battery junction box (BJB) Fuse 6 (15A) and central junction box (CJB) Fuse 18 (5A ,on the lids are the # locations .Are you saying that nothing lights , radio, heater controls , back lighting for the instrument cluster . No check engine light, or any other warning lights . Do all the gauges work ? CJB is located left side of dash . Check the fuse's !

1.Turn off the vehicle. Locate the main fuse box.
2.Locate a fuse box that isn't under the dashboard by checking under the hood of the car.
3.Look at the diagram on the inside of the fuse box's cover.
4.Determine if the fuse is blown by looking through the clear plastic casing.
5.Take the blown fuse to an electronics store or a car-parts store.Push the new fuse into the empty slot in the fuse box, making sure that it is in the same direction as the other fuses. It should slide in with a tight fit.Replace the fuse-box cover.
6.Complete the above steps before removing the car radio.Disconnect the car battery under the hood by disconnecting the cable from the negative terminal (the black cable) of the battery. Remove the dash area around the car radio.Unscrew the four screws on each corner of the car stereo.Locate the fuse on the back of the car radio.

7.Take the blown fuse to a car-parts store or electronics store to find a replacement fuse. Place the new fuse into the car radio.lide the car radio back into the dash opening. Replace the corner screws followed by the dash trim panels. Put any screws and clips back into place.Reconnect the car battery. Turn the car on, and if the blown fuse was the problem, the radio should work.

OBD diagnostic tool one stop supplier

Year make and model ?

look for a blown fuse.

could be as simplet as blown fuse for radio. i would start there. look at your "audio" fuse in the fuse box. if thats ok, then you have something elses goin on, but start with fuse check.

Easy way. With a test light connected to ground ( a test light is a tool that looks like a ice pick with a clear handle with a bulb inside, and a wire coming out the end with a clip on it) Connect the clip on the light to a metal ground under the dash and with the fuse panel where you can see it, touch the pointer to each side of the back of the fuses, with the key on. The light should lght on both sides of a good fuse. If a fuse lights the light on one side and not the other it's blown. For the radio to work three fuses all need to be good as theirs all the time power and key on power and lighting as the dash lights power. The cigar fuse many times provides the all the time power, But if it's blown the radio won't play. Pull one fuse at a time and look at them to see if the bar inside the fuse is good ( they can look good and be bad) back to the test light meathod, Look the fuses up in the owers manul and it'll tell you the location of the fuse but the radio fuse can be good and the radio strill not work as the cigar fuse has to be good too, There;s another fuse panel under the hood that has the main fuses near the battery, Again the test light is fastest and easiest as any fuse blown even though it's not the radio fuse can make the radio not play. Aftermarket radios can have inline fuses instlled by the radio installer and some have fuses right on the back of the radio.

look for fuses in your car look at your manual under fuses and it should tell you were their located

Your going to have to go back to the dealer and they can look up the code by using the vin number of the car to re-set your radio which has an anti theft system.
Most case they'll do it for free where you bought the car as long as it was a Suziki Dealer.
Good luck and hope this helps.

hello . ok first try disconecting the nave unit on the trunk if the radio comes up and the buttons work you have a bad nave unit (very common ) . other option look for radio fuse in glove box top open white tabs on top diconect the fuse and reconnect to see if it will restart the radio pannel if not replace the radio pannel .