1991 Jeep wrangler loses power when acceralating gas? Had towed home. Now it does not start. Had taken into jeep dealer and left for previous problem; it would just quit running. Waiting 10-15 minutes and it would start back up sometimes. Changed coil and we thought it was fixed. Drove 120 miles and now this problem. Can you help with some ideas.

hi there.
not sure if this link will help you out but have a look.
1991 Jeep Wrangler stall and die Google Search

Actually, in some cases, the transmission may have a problem shifting only sometimes, if your TPS, VSS, or any solenoid on the transmission is going bad. an intermittent problem could be the case; and sometimes, it's just a loose wire.

Check out ebay and see if you can get the part there. U can also check your local junkie for a good, used working part.

run a compression check could be blown head gasket

I tow my 2005 Jeep Wrangler behind my motor home. I installed a Jeep trailer towing wiring kit to the rear lights. the bought a long trailer wiring kit and ran it from the front of the Jeep to the Jeep tralier wire plug. Pluged it in and pluged the other end into the motor home trailer light recptacle. I used only four wires plus ground. There is probably a way you could tap into the wiring harnes under the hood but not having a wiring diagram this is the best I could come up with and all lights do work. You can buy a test plug with led lights that plugs in both male and female, real handy for checking connections.

make sure you get a cap from the dealer. I had similar issue.... bought cap from autozone...still threw the code....thought must be something else.

ended up replacing all the vacuum lines ... still threw a code

desperate, bought new cap from dealer.... problem solved!

U have what is called a hydraulic clutch, one of the hydraulic cylinders hs failed, there is a master and a slave cylinder. The most likely and most common cylinder to fail is the slave cylinder, this requires the transmission to be pulled out to replace it. the art is around $125.00, while the trans is out u might as well replace the clutch, the labor is about the same. Here is a picture of the part, let me know if u can see it.

try a tune up even the control module

check all bat. conn. especially the grounds. give it a good t-up plugs cap rotor wires air& fuel filters the next time stalls out hold gas pedal to floor don't pump it.

If you go to www.remcotowing.com it will give you the answer but I think you'll need a trailer.