Question about 1992 Chrysler Town & Country

1 Answer

1992 Chrysler Town and Country overdrive problem

Had a transmission replaced in my T&C last August. Was getting limp home for awhile until they fixed that with a new computer (mostly; still happens rarely). But, cannot get tranny to stay in OD for more than about 6-7 seconds and only one time per start-up. Tired of runaround from tranny guys. Any ideas where I should be looking?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 84 Answers

Start testing speed and position sensors regardless of where they are. Electronic transmissions are sensitive to any of them.

Posted on Oct 30, 2017

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
short shadey
  • 421 Answers

SOURCE: transmission

you need to have the trouble codes read go to autozone they can read them for you and write them down and report back it is most likley a speed sensor on the transmission there is two of them and they are very cheap and easy to change called input /output speed sensors
1 05014469AA Wiring Repair Package, Input Speed Sensor
1 05014471AA Wiring Repair Package, Output Speed Sensor you dont need to use the wiring harness supllied with these sensors as they are for early model vans only please rate -jeff

Posted on Sep 04, 2008

  • 104 Answers

SOURCE: 2002 chrysler town and country wont leave limp mode

P1694 means the battery has been disconnected in the last 50 starts. It could also show up perhaps if the battery is dying or providing low voltage. It can also indicate that the computer memory was cleared in the last 50 starts. Its typically just a status indicator and I would not expect it go into limp home mode unless there is a problem with the battery and its not able to supply the necessary power to engine components.

Posted on Dec 31, 2008

  • 1 Answer

SOURCE: 1996 CHRYSLER TOWN & COUNTRY TRANS AXLE PROBLEM.

i had same toublre on 96 plymouth output speed senor my wont shift out of second

Posted on Jan 17, 2009

alicantecoli
  • 22484 Answers

SOURCE: 2003 chrysler town country natym

please ensure you translater is working correctly ,spanish or english for me ,dont know about other experts on here though

Posted on Feb 15, 2011

early93
  • 177 Answers

SOURCE: I 'm getting codes P0841

I found 4 of the codes. Two of em say you have a pressure sensor error, one says shift solenoid A, and one says gear 1 incorrect ratio. We can ignore the gear ratio one. I bet the issue is either an oil leak, bad shift solenoid, or both.

Posted on Jun 18, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 CHRYSLER TOWN AND COUNTRY TRANSMISSION STUCK IN LIMP MODE


Get the trouble codes read to see what's causing it to be in limp mode. Then fix the problem

May 26, 2018 | Chrysler Cars & Trucks

1 Answer

2003 chrysler town and country limited 3.8litre where is the transmis 2003 Chrysler Town and Country limited recalls 2003 Chrysler Town and Country limited 3.8litre code p1776 how can I fix


It is not a do it yourself fix.

This is an automatic transmission issue which may involve replacing the valve body and solenoid pack and affects transmissions fitted to various Chrylser models. It could also be a symptom of more serious transmission problems and requires proper investigation and diagnosis.

On some models there was a Technical Service Bulletin issued to dealers on this problem .

Dec 15, 2015 | Chrysler Cars & Trucks

1 Answer

My Chrysler Town and Country 2001 is in limp mode.


you cant get rid of the issue until you find the cause and fix it. i would not recommend throwing any more parts at it, get someone with a scan tool and see what codes are there before you waste any more money
.

May 21, 2012 | 2001 Chrysler Town & Country

1 Answer

My 2007 Chrysler T&C is in limp mode Please help. I had a squirrel chew through a wiring harness, all went back together well except when I came to 5 wires; 3 of the wires are green with a purple...


Could be at least a dozen different causes. YOu're assuming that it has to do with your wiring. But you really don't know until you get trouble codes read. Guessing is not diagnosing. Get the codes read and THEN post the code here andask for help if you can't figure it out.

Sep 22, 2017 | 2007 Chrysler Town & Country LX New Cars

1 Answer

My trans is stuck in second gear. Is that what


The town and country vans are know for transmission problems and it would not be stuck in 2nd gear if it was in limp mode. Limp mode typically controls the engine. I have seen people do a transmission flush/filter and add lucas to temporary fix the problem. There is also a good chance that the transmission has a solenoid problem preventing it from shifting into any other gears but second. Hope this helps!

Jul 30, 2010 | 2002 Chrysler Town & Country

1 Answer

Transmission is working but light came on


I recommend going toa transmission repair shop and having the TCU scanned for codes and repaired before the vehicle goes into the "limp home mode".
You only have third and reverse in this mode.

May 11, 2010 | 2002 Chrysler Town & Country

2 Answers

2002 chrysler town and country wont leave limp mode


try getting a new shift solenoid for it. i had the same problem on my 2002 chrysler town and country and my plymouth breeze which is also a dodge product. it is very simple to do and doesnt take all that long. the part will probably run you about 150 to 200 dollars but it should fix your problem.

Dec 31, 2008 | 2002 Chrysler Town & Country

Not finding what you are looking for?
1992 Chrysler Town & Country Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...