Hello: You have a failed temperature control actuator for the passenger air mix door. Remove the glove box and the close out panel under the dash on the passenger side. You will see two silver rods going from the actuators (mounted on the top and bottom of the heater/a/c programmer) Turn key on (engine off) Turn the a/c heater control on. Go from 60 to 90 or 90 to 60 and watch the rods the one that doesn't move is the failed one. The actuator is held in place by two 7mm screws and one electrical connector. When installing the new actuator have the temp set at 60 when you hook up the linkage. The passenger side set at full cold.
1,281 views
Usually answered in minutes!
×