Cars & Trucks Logo

Related Topics:

Posted on Nov 11, 2010

06 SUBARU TRIBECA THE ALARM SYSTEM KEEPS GOING OFF FOR NO REASON.

5 Related Answers

Anonymous

  • 186 Answers
  • Posted on May 13, 2009

SOURCE: alarm keeps going off after i lock car with security system on

most likely a door pin switch or trunk switch malfunction or switch adjustment.hope this helps

Ad

Anonymous

  • 776 Answers
  • Posted on Jun 06, 2009

SOURCE: My alarm on my 2002 Hyundai Sonata keeps going off

Experience with this problem points to several possible causes. First, hood switch is improperly adjusted or rubber button on the underside of the hood which strikes this switch is missing or worn out (does the 'answer back' feature (horn toot) occur when you press the "lock" button on the keyless remote twice?). If it doesn't, this is the first place to look -- is the hood bent out of shape? Often I have found the hood adjustment is SO CLOSE to the hood switch being 'CLOSED', that a simple gust of WIND can set off the alarm.
Next, each door and the trunk have switches which must be in their proper positions (closed -- Open Circuit communication with the ETACS module) for the burglar alarm to SET Active/ON. The problem could be at any one of these switches, not to mention the ETACS module itself. Best solution:Take/tow the vehicle into a Hyundai Service Center (dealership), pay the diagnostic fee. They will tell you EXACTLY what the problem is and what's needed to fix it (parts, labor, tax, time-frame, etc.).

kirtec auto

  • 1348 Answers
  • Posted on Jul 13, 2009

SOURCE: How do I reset factory alarm on a 2000 Subaru

you HAVE to get a remote and unlock the car.the dealer may be able to turn it off with the obd2 system,you have to call subaru.

subytech1

Brandon Johnson

  • 253 Answers
  • Posted on Aug 09, 2009

SOURCE: 2006 subaru B9 Tribeca Error 66

Hello, I know exactly what your talking about! and why no one else did... The error code is being displayed on your trip/odo LCD screen at the bottom of your right gauge pod if I remember correctly. Only, it\'s not Er 66... it\'s (Er bb) which is a malfunction with your vacuum pump system. I truly hope this is the same concern you are asking about, if so I am happy I could help. If it is a different problem please let me know so I can look into this matter further. I\'ve added an "error chart guide" so you will have proof this time when/if you decide to return to the dealer... Good luck!! and I hope this info helps...(subytech1)...143162913

Anonymous

  • 14 Answers
  • Posted on Aug 19, 2009

SOURCE: subaru tribeca lights

DO NOT buy bulbs anywhere other than SUBARU as replacement. They are specifically long life bulbs. Yes, availlable in other brands in other stores and more cost efficient but not in the long run..

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Subaru Tribeca B9 Misfiring

Misfire can create a lot of heat. Especially in the catalytic converter. usually a crank sensor results in no start but it affects the ignition timing. What are the exact codes?
1helpful
2answers

My radio, car alarm, interior lights do not work on my 2006 subaru tribeca

The solution for the interior lights temp gauge etc. not working is the fuse under the hood as mentioned above.
As for the clock resetting, your battery is probably about to go. The tribeca turns off power to the vehicle if voltage drops below a certain level to save enough power to start back up. This causes the clock to lose memory.
0helpful
1answer

How do I replace the fog light bulb in my 06 subaru tribeca

LOOK IN THE OWNERS MANUAL IN THE GLOVE COMPARTMENT,LOOK IN THE BACK INDEX OF MANUAL, LOOK UP BULB REPLACEMENT.IT WILL SHOW YOU HOW TO REPLACE FOG LIGHT BULB.USE LATEX WHEN CHANGING FOG LIGHT BULBS, BECAUSE LIGHT BULBS IS HALOGEN IF TOUCH WITH FINGERS OR HANDS, OILS FROM HANDS WILL CAUSE HALOGEN OVERHEAT AND BLOW OUT.
1helpful
1answer

Where is the crank sensor located on a 06 tribeca?

Looking at your engine, the largest pulley on the bottom is your crank pulley, right above it, and below your timing cover is where you'll find it
3helpful
3answers

Subaru Tribeca 2006; the radio stopped working the interiors lights don't turn on, the lights for the temperature gages don't turn on and the alarm system does not work. Also every time I turn on the car...

had the same problem. no radio, navigation interior lights etc. replaced 20 amp fuse labeled "back up" in the engine compartment fuse box and all checks good.
0helpful
1answer

Is the pin fixed in the subaru tribeca wiper arm or does it pop out

I think so i just talked to the dealer and they said you need to buy the subaru blades.... it's a total racket. I just bought two new bosch blades from napa and I have now way to put them on the tribeca. so now i have to return them and i'm going to buy a blade refill from subaru b/c the whole blades are 2x as much as the aftermarket replacements. If anybody knows of a way to get aftermarket blades on the tribeca please let me know!
1helpful
1answer

How do I reset factory alarm on a 2000 Subaru

you HAVE to get a remote and unlock the car.the dealer may be able to turn it off with the obd2 system,you have to call subaru.
0helpful
1answer

2006 subaru B9 Tribeca Error 66

http://www.cars101.com/subaru/keyless.html this site has a lot of info on the car and a coding system which might turn the error off :D
Not finding what you are looking for?

588 views

Ask a Question

Usually answered in minutes!

Top Subaru Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Oliver Street

Level 2 Expert

73 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...