Seat belt When I close the door the seatbelt wont retract. I tried to pull it manually nd it goes up but thwn i open the door it comes back down.

If it's that tight it would be easier to remove the lower back seat and remove the 18 mm bolt and remove the seatbelt anchor. To remove the lower back seat pull up sharply on the front left and right sides of seat, only held in with plastic clips, then seat will pull forward and ouy

There are a number of reasons why a car door won't open. First, make sure the car is unlocked. If it is, check the seatbelt. If your seat belt does not fully retract, it may be closed up inside the door of the car. Sometimes when this happens, the door closes with the seat belt positioned over the door's latching mechanism, causing everything to jam. Read more: Reasons a Car Door Won't Open ' eHow.com http://www.ehow.com/way_5390808_reasons-car-door-wont-open.html#ixzz1tFeulJqO ------------------------------------------------------------------
godiag key programmer

you could try some WD 40 spray into the mechanism but if that doesnt work then its down to renewing the whole seat belt .no easy way as they are sealed units and try to repair and the spring goes PING and it all come apart

if you can pull the belt out, it should go back on its own, otherwise its a new belt,its a "no fix" item.

middle seat belt shouldn't have anything to do with it. The seat locks down for stowage in the rear cargo area. you can pull the release handle on the back of the seat to release it back into the up position.

Seat belts are not repairable. A replacement must be done (new or used)

Is this a NEW seat belt?  Or a junkyard part... Per the Toyota 1988 Repair Manual - the belt is allowed to be pulled out at a tile of 15 degrees or less; and cannot be pulled out at over 45 degrees of tilt.

Your problem is the belt is not retracting.  The manual states to replace the assembly.  It also states: "Whenver installing a new belt assembly, verify proper operation before installation."

If a new part does not have proper operation; have it replaced. If this is a 'used'  new part - get a NEW seat belt.

Not a fix but just pull it over the seat and fasten it...At least it want go off while driven alone.

http://www.toyotanation.com/forum/showthread.php?t=300887
Full version about Automatic Seatbelt troubleshooting for 87-91 Camry written by Professor Oleg Turkin

2000 Honda Odyssey the middle seat belt is broken. The seatbelt won't retract. The end of the belt does not come out but the entire seatbelt will come out of the hole.
Any suggestions?