I purchased a cabin filter but i could not locate its installation point. I looked everywhere in side the cab; even removed the gove box, i found everything else---duct---heat exchanger---cleaned all of it but did not find an air filter. So i assume there is not an inside cabin filter?? Do you know where i can get (other than the ford dealer) the dealer option under the dash kit?
thanks,
Phil
SOURCE: cabin air filter
All information contained here and on subsequent pages are subject to the myFordFocus.com Terms of Use Policy, which basically states that myFordFocus.com IS NOT responsible for anything you do to your car... Please read it! :)
Cabin Air Filter Installation
Annoyed with all the pollen and dust in your interior? Unless you special ordered it, Ford left out the cabin air filter.
Here's how to install one in your Focus.
Compliments of myFordFocus.com Forum Member: CinnabonBoy
Cost: $10.00
Time to Complete: 10 minutes
Tools Required:
Parts Needed:
Instructions: (Click images to Enlarge)
SOURCE: 1998 f250 cabin air filter location
Ford pickups/expeditions do not have cabin/pollen air filters.sorry.
SOURCE: LOCATE AC CABIN AIR FILTER
no cabin filter on 2003 crown vic cabin filter is under pass cowl trim
SOURCE: where is cabin ac filter located
If the air conditioner emits a foul odor into the cabin it is probably the drain tube on the evaporator core is clogged. What happens is the clog causes mildew to start growing and then it blows the stink right into the car. And to answer your question the cabin air filter location all depends on the year make and model of the car.
SOURCE: cabin air filter
Tools needed are a Phillips screwdriver. Open the hood. Notice the cover for the cabin filter is on the cowl on the passenger side. Remove the screw form the cover.
Remove the cover by pulling toward the front of the vehicle. The filter is now visible. Remove by pushing up on the filter to loosen from housing and then pulling out toward the front of the vehicle.
Replace with clean cabin filter. Replace cover by lining up the notches on either side of the cover plate to the grooves in the filter housing. Replace the screw in the cover plate.
Good luck and hope this helps.
299 views
Usually answered in minutes!
×